Stimmen - 4, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
7). Is TRIGGER BANK 2 selected? Set to the trigger bank 2 factory settings. * Only the factoiy-defnu.lt settings of trigger bank 2 can be copied. [SETUP] - [F1 (TRIG)] - [F1 (BANK)] - [TOOLS] - [F1 (COPY)] No sound is heard The trigger type is set to CTR (TDW-1 with V-Cymbal Control only). When the trigger type is set to CTR, the "head-side" sound will not be heard (p. 9). Set the trigger type to a pad that you are using, such as RdA or CrB. The sound does not change when a bell shot is made The connection is to the BOW/EDGE output. Make the connection to the BOW/BELL output to enable the CY-15R to support bell shots. * The CY-14C and CY-12H do not support bell shots. Choke play is not possible Choke an area where an edge sensor is located. The CY-15R and CY-14C have edge sensors only at the areas closest to you, at the front (p. 8). Sounds play twice Are any of the cables touching the units (V-Cymbals)? Secure the cables in place with the cable ties so that they do not touch the units. Also, be careful to make sure that the cables are not pulled by the movement of a cymbal when struck (p. 6). Are the stopper, felt washer, and wing nut attached correctly? Double triggering may occur if the stopper and/or wing nut is loose. Use a drum key to tignten properly. * If double triggering still occurs, try adjusting trigger parameters, such as Retrigger Cancel, on the sound module you are using (TD-10, etc.). The sound does not vary when the striking position changes The CY-15R and CY-14C are capable of the positional detection feature. Positional detection is possible when plugged into the specified input on a Roland sound module with this feature. Sounds that change according to playing position are The sound does not change when an edge shot is made The connection is to the BOW/BELL output. j Make the connection to the BOW/EDGE output to j enable the CY-15R to support edge shots. j Strike an area where an edge sensor is located. The CY-15R and CY-14C have edge sensors only at the j areas closest to you, at the front (p. 8). j certain ride cymbal tones. For more information, refer to the instrument list in the owner's manual for the sound module. With trigger types RdB and CrB, positional sensing is not possible. Use RdA or CrA. * The CY-12H does not support positional sensing. The Volume Level is Too Low Striking the cymbal units when turning on the power of the sound module (TD-10, etc.) degrades the unit response when the units are struck lightly. Do not strike any cymbal units when turning on the power. 12 r Specifications CY-15R (Ride) Size: 15 inches Trigger: 3 (Bow/Bell/Edge) * When the TDW-1 toil It V-Cymbal Control is not being used, select "Bow/Bell" or "Bow/Edge. Connectors: BOW/BELL Output Jack, BOW/EDGE Output Jack Dimensions: 376 (W) x 376 (D) x 50 (H) mm 14-13/16 (W) x 14-13/16 (D) x 2 (H) inches Weight: 1.6 kg 3 lbs 9 oz Accessories: Owner's Manual, Wing Nut, Felt Washer, Stopper, Connection Cable x 2, Cable Tie Options: Cymbal Mount (MDY-7U, MDY-10U) CY-14C (Crash) Size: 14 inches Trigger: 2 (Bow/Edge) Connector: BOW/EDGE Output Jack Dimensions: 352 (W) x 352 (D) x 48 (H) mm 13-7/8 (W) x 13-7/8 (D) x 1-15/16 (H) inches Weight: 1.4 kg 3 lbs 2 oz Accessories: Owner's Manual, Wing Nut, Felt Washer, Stopper, Connection Cable, Cable Tie Options: Cymbal Mount (MDY-7U, MDY-10U) CY-12H (Hi-Hat) Size: 12 inches Trigger: 2 (Bow/Edge) Connector: BOW/EDGE Output Jack Dimensions: 302 (W) x 302 (D) x 116 (H) mm 11-15/16 (W) x 11-15/16 (D) x 4-5/8 (H) inches Weight: 1.8 kg 4 lbs Accessories: Owner's Manual, Connection Cable Options: Pad Mount (MDH-7U, MDH-10U) * In the interest of product improvement, the specifications and /or appearance of this unit are subject to change without prior notice. 13 Information When you need repair service, call your nearest Roland Service Center or authorized Roland distributor in your countiy as shown below. (AFRICA) EGYPT A1 Fanny Trading Office P.O. Box 2904, El Horrieh I leliopolos, Cairo, EGYPT TEL: (02) 4185531 REUNION Maison FO - YAM Marcel 25 Rue Jules Hermann, Chaudron-BP79 07 4lU Ste C lotilde Cedex, REUNION ISLAND I I I 28 24 lb SOUTH AFRICA That Other Music Shop (PTY) Ltd. II Melle St., Braamfontein, [ohannesbourg Republic of SOUTH AFRICA P.O.Box 3291S, Braamfontein 2017 Republic of SOUTH AFRICA TEI.: (011 >403 4105 Paul Bothner (PTY) Ltd. 17 VVerdnmller Centre Claremont 771)0 Republic of SOUTH AFRIC A P.O. Box 23032 Claremont, Cape Town SOUTH AFRICA, 77.35 TEL: (021)674 4030 (asia) CHINA Beijing Xinghai Musical Instruments Co., Ltd. 6 Huangmuchang Chao Yang District, Beijing, Ci-ilMA TEL: (010)6774 74^1 HONG KONG Tom Lee Music Co., Ltd. Service Division 22-32 Pun Shan Street, Tsuen Wan, New Territories, HONG KONG TEL: 2415 091 1 INDIA Rivera Digitec (India) Pvt. Ltd. 409, Nirman Kendra Mahalaxmi Flats Compound Off. Dr. Edwin Moses Ruad, Mumbai-400011, INDIA TEL: (022) 498 3079...