Stimmen - 4, Durchschnittliche Bewertung: 4 ( )

Hersteller: B.C. Rich Dateigröße: 428.44 kb Dateiname: Unterrichtssprache:

It controls the loudness of this pickup. • The next control is the 3-way Pickup Selector. It is used to switch the two pickups on or off. Switching the selector up will engage the neck pickup. The middle position engages both pickups, and switching it down will engage the bridge pickup. • The next control is the Volume Control for the neck pickup. It controls the output of this pickup. • The final control is the Master Tone Control.This changes the tonal characteristics of the pickup(s) currently engaged. NJ and Innovator Series basses NJ Basses come equipped with 2 split-coil pickups with an active EQ system. Innovator Basses come equipped with 2 EMG-HZ passive pickups with an Active EQ System. Both Active EQ Systems use a 9-volt alkaline battery for power. For longer battery life, always unplug your bass when not in use. 2 Step 6: If you're ready to float the tremolo, check your tuning one last time and make any needed adjustments using the range tuner set screw.Then, back the tremolo stop set screw away from the spring block.This will cause the bridge to tilt back toward the body of the guitar and all the strings will go sharp.This is normal. Step 7: You must now retune the guitar, this time using a Phillips screwdriver to turn the spring claw screws counterclockwise to loosen the spring tension (If you added an extra spring to pull the spring block against the tremolo stop screw you should remove it first.) Step 8: The good news is that you only have to retune one string. Pluck the string you want to tune (Typically the "A" string for this procedure) and then, while watching the tuner, loosen first one claw screw then the other claw screw the same amount. Check the tuning and repeat until the string is in tune.When you get the string you chose in tune the other strings will be in tune.This assumes that all the strings were in tune before you released the tremolo stop. For foreign language translation of this owner's manual, please visit 15 tuning using the range tuner set screw. Remember: do not use the fine tuner screws to tune the guitar at this point. Step 4: A range tuner setscrew is located in the nose of each pivoting saddle. Step 5: Using a 1.5mm Allen wrench and the range tuner setscrew, tune your guitar to any tuning you desire.You can increase the pitch of a given string by turning the setscrew clockwise, and decrease the pitch of the string by turning the setscrew counterclockwise. (Remember not to use the fine tuner screws for this tuning.) Now that you have tuned your guitar to the tuning you want, the bridge should be properly setup, and the fine tuners should be set to the middle of their range. The way your guitar is set up now is what is called a "blocked" setup.This means that the tremolo can be used for dive effects but you can't pull up on the arm for up bends.You can leave your guitar the way it is, or you can disengage the tremolo stop to return the tremolo to what is called a "floating" setup. However, b...

Herunterladen

Geben Sie zwei Ziffern: