Stimmen - 3, Durchschnittliche Bewertung: 3.3
(
)
)
|
Anleitung Zusammenfassung
Reparaturen nur von qualifiziertem Fachpersonal durchführen lassen. ACHTUNG Um einen clcktrischen Schlag oder Feuergefahr zu vermeiden, sollte dieses Gerät nicht dem Regen oder Feuchtigkeit ausgesetzt werden. Vor Inbetriebnahme unbedingt die Bedienungsanleitung lesen. ENGLISH 11 12 10 HIGH GAIN INPUT (1) Used for most electric guitars. It is 6 dB louder than the Low Gain input. LOW GAIN INPUT (2) Provided for instruments that have extremely high outputs, which can result in overdriving (distorting) the High Gain input. If both inputs are used simultaneously, the output levels are the same (both are Low Gain). PRE GAIN (3) Controls the input volume level of the amplifier. BRIGHT SWITCH (4) Provides a preset boost (±8 dB) to treble frequencies. To activate, depress the switch to its “in” position. PUNCH SWITCH (5) Provides a preset boost (±8 dB) to midbass frequencies. To activate, depress the switch to its “in” position. POST GAIN (6) Controls the overall volume level of the amplifier. The final level adjustment should be made after the desired sound has been achieved. LINE PATCH (7) Provided for connecting external effects devices into the signal path. To patch an effects device, connect the send jack to the input of the device. Connect the output of the device to the return jack. High quality shielded cable should be used for these connections. LOW (8) An active tone control (shelving type, ±15 dB) that varies the low frequency boost or cut. OPERATION NOTE: Excessive EQ boost, especially of the low frequencies, increases the possibility of speaker damage, and sacrifices valuable headroom. GRAPHIC EQUALIZER (9) This seven-band, one octave equalizer provides 15 dB of boost or cut at each center frequency. HIGH (10) An active tone control (shelving type, ±15 dB) that varies the high frequency boost or cut. COMPRESSION LED (11) The amplifier is equipped with the patented DDT compression circuit (US Patent 4,318,053). The compression circuit eliminates audible power amp clipping, reduces distortion, and protects the loudspeaker. In use the compression LED may occassionally illuminate, indicating that the compressor is engaging to prevent distortion. If the LED is continuously illuminated, Gain control or Low EQ control settings should be reduced to prevent possible loudspeaker damage. PILOT LED (12) Illuminates when AC power is being supplied to the amp. 15 16 LINE CORD (120V PRODUCTS ONLY) (13) For your safety, we have incorporated a 3-wire line (mains) cable with proper grounding facilities. It is not advisable to remove the ground pin under any circumstances. If it is necessary to use the equipment without proper grounding facilities, suitable grounding adaptors should be used. Less noise and greatly reduced shock hazard exists when the unit is operated with the proper grounded receptacles. FUSE (14) The fuse is located within the cap of the fuseholder. If the fuse should fail, IT MUST BE REPLACED WITH THE SAME TYPE AND VALUE IN ORDER TO AVOID DAMAGE TO THE EQUIPMENT AND TO PREVENT VOIDING THE WARRANTY If the amp repeatedly blows fuses, it should be taken to a qualified service center for repair. WARNING: THE...
Dieses Handbuch ist für folgende Modelle:Musikinstrumente - Mark III 300 CHS (3.25 mb)