Hersteller: Sony
Dateigröße: 468.44 kb
Dateiname:
|
Dieses Gerät hat auch andere Anweisungen:
Anleitung Zusammenfassung
The color irregularity on a TV screen persists. •Turn off the TV set once, then turn it on after 15 to 30 minutes. If the color irregularity still persists, place the speakers farther away from the TV set. “PROTECT”and “PUSH POWER” appear alternately. •A strong signal was input. Press ?/1 to turn off the power, leave the system turned off for a while, then press ?/1 again to turn on the power. •Check the speaker cables in case “PROTECT” and “PUSH POWER” appear alternately again after you turn the system on. Speakers Sound comes from one channel or unbalanced left and right volume. •Check the speaker connection and speaker placement. Sound lacks bass. •Check that the speaker’s + and – jacks are connected correctly. CD Player The CD tray does not close. •The CD is not placed properly. The CD will not play. •The CD is not lying flat in the disc tray. •The CD is dirty. •The CD is inserted label side down. •Moisture condensation has built up. Remove the CD and leave the system turned on for about an hour until the moisture evaporates. Play does not start from the first track. •The player is in program or shuffle mode. Press PLAY MODE repeatedly until “PGM” or “SHUFFLE” disappears. “OVER” is displayed. •You have reached the end of the CD. Turn SHUTTLE counterclockwise. continued Troubleshooting (continued) Tape Deck The tape does not record. •No tape in the cassette holder. •The tab has been removed from the cassette (see “To save a tape permanently” on page 41). •The tape has reeled to the end. The tape does not record nor play or there is a decrease in sound level. •The heads are dirty. Clean them (see “Cleaning the tape heads” on page 42). •The record/playback heads are magnetized. Demagnetize them (see “Demagnetizing the tape heads” on page 42). The tape does not erase completely. •The record/playback heads are magnetized. Demagnetize them (see “Demagnetizing the tape heads” on page 42). There is excessive wow or flutter, or the sound drops out. •The capstans or pinch rollers are dirty. Clean them (see “Cleaning the tape heads” on page 42). Noise increases or the high frequencies are erased. •The record/playback heads are magnetized. Demagnetize them (see “Demagnetizing the tape heads” on page 42). Tuner Severe hum or noise (“TUNED” or “STEREO” flashes in the display). •Adjust the antenna. •The signal strength is too weak. Connect the external antenna. A stereo FM program cannot be received in stereo. •Press STEREO/MONO so that “MONO” disappears. If other troubles not described above occur, reset the system as follows: 1 Press x, ENTER and ?/1 at the same time. 2 Unplug the power cord. 3 Plug the power cord back in. 4 Press ?/1 to turn on the power. The unit is reset to factory settings. All the settings you made, such as the preset stations, clock, and timer are cleared. You should set them again. Specifications AUDIO POWER SPECIFICATIONS: (MHC-BX7 USA models only) POWER OUTPUT AND TOTAL HARMONIC DISTORTION with 6 ohm loads both channels driven, from 120-10,000 Hz; rates 115 watts per channel minimum RMS power, with no more than 10% total harmonic distortion from 250 milliwatts to rated output. Total harmonic distortion less than 0.07% (6 ohms at 1 kHz, 60 W) (MHC-BX5 USA models only) POWER OUTPUT AND TOTAL HARMONIC DISTORTION with 6 ohm loads both channels driven, from 120-10,000 Hz; rates 95 watts per channel minimum RMS power, with no more than 10% total harmonic distortion from 250 milliwatts to rated output. Total harmonic distortion less than 0.07% (6 ohms at 1 kHz, 50 W) Amplifier section Canadian model: MHC-BX7 Continuous RMS power output (reference) 120 + 120 watts (6 ohms at 1 kHz, 10% THD) Total harmonic distortion less than 0.07% (6 ohms at 1 kHz, 60 W) MHC-BX5 Continuous RMS power output (reference) 80 + 80 watts (6 ohms at 1 kHz, 10% THD) Total harmonic distortion less than 0.07% (6 ohms at 1 kHz, 50 W) European model: MHC-BX9 DIN power output (rated) 130 + 130 watts (6 ohms at 1 kHz, DIN) Continuous RMS power output (reference) 170 + 170 watts (6 ohms at 1 kHz, 10% THD) Music power output (reference) 285 + 285 watts (6 ohms at 1 kHz, 10% THD) MHC-BX7 DIN power output (rated) 80 + 80 watts (6 ohms at 1 kHz, DIN) Continuous RMS power output (reference) 100 + 100 watts (6 ohms at 1 kHz, 10% THD) Music power output (reference) 170 + 170 watts (6 ohms at 1 kHz, 10% THD) MHC-BX5 DIN power output (rated) 80 + 80 watts (6 ohms at 1 kHz, DIN) Continuous RMS power output (reference) 100 + 100 watts (6 ohms at 1 kHz, 10% THD) Music power output (reference) 170 + 170 watts (6 ohms at 1 kHz, 10% THD) Other models: MHC-DX9 The following measured at AC 120, 220, 240V 50/60 Hz DIN power output (rated) 220 + 220 watts (4 ohms at 1 kHz, DIN) Continuous RMS power output (reference) 300 + 300 watts (4 ohms at 1 kHz, 10% THD) MHC-DX7 The following measured at AC 120, 220, 240V 50/60 Hz DIN power output (rated) 160 + 160 watts (6 ohms at 1 kHz, DIN) Continuous RMS power output (reference) 200 + 200 watts (6 ohms at...
Dieses Handbuch ist für folgende Modelle:Stereoanlage - MHC-BX5 (468.44 kb)
Stereoanlage - MHC-BX7 (468.44 kb)
Stereoanlage - MHC-BX9 (468.44 kb)
Stereoanlage - MHC-DX5 (468.44 kb)