Stimmen - 3, Durchschnittliche Bewertung: 4
(
)
)
|
Dieses Gerät hat auch andere Anweisungen:
Anleitung Zusammenfassung
Noise increases or the high frequencies are erased. •The record/playback heads are magnetized. Demagnetize them (see “Demagnetizing the tape heads” on page 50). After pressing ((9) or ¤, there is a mechanical noise, “EJECT” appears in the display, and the unit enters standby mode automatically. • The cassette tape was not inserted correctly. Eject the tape and turn the power back on. Tuner Severe hum or noise (“TUNED” or “STEREO” flashes in the display). •Adjust the antenna. •The signal strength is too weak. Connect the external antenna. A stereo FM program cannot be received in stereo. •Press STEREO/MONO so that “STEREO” appears. If other troubles not described above occur, reset the system as follows: 1 Unplug the power cord. 2 Plug the power cord back in. 3 Press p, ENTER/NEXT, and DISC 1 at the same time. 4 Press to turn on the power. MHC-GRX10AV (Other models): Specifications Amplifier section MHC-RX110AV (Canadian models): Front Speaker: Continuous RMS power output (reference) 120 + 120 watts (8 ohms at 1 kHz, 10% THD) Total harmonic distortion less than 0.07% (8 ohms at 1 kHz, 65 W) Center Surround Speaker: Continuous RMS power output (reference) 25 watts (8 ohms at 1 kHz, 10% THD) Rear Surround Speaker: Continuous RMS power output (reference) 12.5 + 12.5 watts (16 ohms at 1 kHz, 10% THD) MHC-RX110AV (European and Russian models): Front Speaker: DIN power output (rated) 80 + 80 watts (8 ohms at 1 kHz, DIN) Continuous RMS power output (reference) 100 + 100 watts (8 ohms at 1 kHz, 10% THD) Music power output (reference) 170 + 170 watts (8 ohms at 1 kHz, 10% THD) Center Surround Speaker: DIN power output (rated) 20 watts (8 ohms at 1 kHz, DIN) Continuous RMS power output (reference) 25 watts (8 ohms at 1 kHz, 10% THD) Music power output (reference) 45 watts (8 ohms at 1 kHz, 10% THD) Rear Surround Speaker: DIN power output (rated) 10 + 10 watts (16 ohms at 1 kHz, DIN) Continuous RMS power output (reference) 12.5 + 12.5 watts (16 ohms at 1 kHz, 10% THD) Music power output (reference) 20 + 20 watts (16 ohms at 1 kHz, 10% THD) The following measured at AC 120, 220, 240 V 50/60 Hz Front Speaker: DIN power output (rated) 105 + 105 watts (6 ohms at 1 kHz, DIN) Continuous RMS power output (reference) 130 + 130 watts (6 ohms at 1 kHz, 10% THD) Center Surround Speaker: DIN power output (rated) 20 watts (8 ohms at 1 kHz, DIN) Continuous RMS power output (reference) 25 watts (8 ohms at 1 kHz, 10% THD) Rear Surround Speaker: DIN power output (rated) 10 + 10 watts (16 ohms at 1 kHz, DIN) Continuous RMS power output (reference) 12.5 + 12.5 watts (16 ohms at 1 kHz, 10% THD) Peak music power output (reference) 2000 watts Inputs VIDEO IN: voltage 250 mV, (phono jacks) impedance 47 kilohms MD IN: voltage 450 mV, (phono jacks) impedance 47 kilohms MIX MIC: (phone jack) sensitivity 1 mV, impedance 10 kilohms Outputs MD OUT: voltage 250 mV (phono jacks) impedance 1 kilohms PHONES: accepts headphones of 8 (stereo phone jack) ohms or more FRONT SPEAKER: accepts impedance of 8 to 16 ohms REAR SURROUND SPEAKER: accepts impedance of 16 ohms CENTER SURROUND SPEAKER: accepts impedance of 8 ohms SUPER WOOFER: Voltage 1 V, impedance 1 kilohms continued Specifications (continued) CD player section System Laser Laser output Frequency response Wavelength Signal-to-noise ratio Dynamic range Compact disc and digital audio system Semiconductor laser (l=780nm) Emission duration: continuous Max. 44.6 mW* *This output is the value measured at a distance of 200 mm from the objective lens surface on the Optical Pick-up Block with 7 mm aperture. 2 Hz – 20 kHz (±0.5 dB) 780 – 790 nm More than 90 dB More than 90 dB Tuner section FM stereo, FM/AM superheterodyne tuner FM tuner section Tuning range 2 band models: 87.5 – 108.0 MHz 3 band (FM–MW–SW) models: 87.5 – 108.0 MHz 3 band (FM–MW–LW) models: 87.5 – 108.0 MHz 4 band models: 87.5 – 108.0 MHz Antenna FM lead antenna Antenna terminals 75 ohm unbalanced Intermediate frequency 10.7 MHz UKV tuner section (4 band model only) Tuning range 65.0 – 74.0 MHz Stereo Plus AM tuner section Tuning range 2 Band type: North American models: 530 – 1,710 kHz (with the interval set at 10 kHz) 531 – 1,710 kHz (with the interval set at 9 kHz) Other models: 531 – 1,602 kHz (with the interval set at 9 kHz) 530 – 1,710 kHz (with the interval set at 10 kHz) 3 Band/4 Band type: European and Russian models: MW: 531 – 1,602 kHz (with the interval set at 9 kHz) LW: 153 – 279 kHz (with the interval set at 3 kHz) Middle Eastern models: MW: 531 – 1,602 kHz (with the interval set at 9 kHz) SW: 5.95 – 17.90 MHz (with the interval set at 5 kHz) Other models: MW: 531 – 1,602 kHz (with the interval set at 9 kHz) 530 – 1,710 kHz (with the interval set at 10 kHz) SW: 5.95 – 17.90 MHz (with the interval set at 5 kHz) Antenna AM loop antenna Antenna terminals External antenna terminal Intermediate frequency 450 kHz Wavelength Output Level Tape player section Recording system Frequency response (DOLBY NR OFF) Wow and flutter CD OPTICAL...