Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Anleitung Zusammenfassung
SLEEP Set the sleep timer. TIMER Set the alarm timer. DISPLAY During play, select display information. Display available RDS (Radio Data System) information of an FM radio station. OL +/- Adjust volume. Adjust time. MUTE Mute volume. Adjust brightness of the display panel. LOUD Enable or disable automatic loudness adjustment for bass and treble enhancement. Select a preset sound setting. Turns on or off dynamic bass enhancement.. SHIFT Enter a 2 or 3-digit number (used together with the numeric keypad). o Numeric keypad • Select a track from a disc directl p PRESET/ALBUM +/- • • Skip to the previous/next album. Select a preset radio station. q • Stop play or erase a program. r CL• OCK Set the clock. s • • / Fast reverse or fast forward within a track or disc. Tune to a radio station. t • Star t or pause play. u / • • Skip to the previous/next track. Select a preset radio station. v O• PEN/CLOSE Open or close the disc tray. w SH• UFFLE Play tracks randomly. x RE• • PEAT/ST. Select a repeat play mode. Select stereo or mono sound output for an FM radio station. 12 Connect FM antenna Tip • For optimal reception, fully extend and adjust the position of the antenna. • For better FM stereo reception, connect an outdoor FM antenna to the FM AERIAL jack. • The unit does not support MW radio reception. 1 Connect the supplied FM antenna to the FM AERIAL jack on the main unit. a b c 3 Get started Caution • Use the controls only as stated in this user manual. Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of your unit. The model number and serial number are on the bottom of your unit. Write the numbers here: Model No. __________________________ Serial No. ___________________________ Connect speakers Note • Ensure that the colors of the speaker wires and terminals are matched. • For optimal sound, use the supplied speakers only. • Connect only speakers with impedance that is the same or higher than the supplied speakers. Refer to the Specifi cations section of this manual. 1 Hold down the socket fl ap. 2 Insert the stripped part of the wire completely. • Insert the right speaker wires to “R ”, left speaker wires to “ L”. • Insert the red wires to “+ ”, black wires to “ -”. 3 Release the socket fl ap. EN Risk of product damage! Ensure that the power supply oltage corresponds to the voltage printed on the back or the underside of the unit. Risk of electric shock! When you unplug the AC power ways pull the plug from the socket. Never pull the cord. ore you connect the AC power cord, ensure that e completed all other connections. Connect the power cord to the AC~ jack on the main unit. Connect the power plug to the wall outlet. epare the remote control Caution Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire. rst-time use: Remove the protective tab to activate the remote control batter y. eplace the remote control batteries: Open the batter y compar tment. t one lithium CR2025 batter y with • If you are not going to use the remote control f long time, remove the batter y. Set clock 1 In the standby mode, press and hold CLOCK to activate the clock setting mode. » The hour digits are displayed and begin to blink. » If the hour digits are not display press and hold for more than 2 seconds to switch to standby mode then repeat step 1. 2 Press + VOL - to set the hour. » The minute digits are displayed and begin to blink. 3 Press + VOL - to set the minute. 4 Press CLOCK to confirm the clock setting. Turn on 1 Press . » The unit switches to the last selected source. Switch to standby mode 1 Press to switch the unit to Eco P Standby mode. » The backlight on the display panel turns off. » The blue Eco Power indicator tur display panel. The blue Eco Power indicator turns off. CD to select the CD source. OPEN/CLOSE. The disc tray opens. Place a disc onto the tray and press OPEN/CLOSE. Ensure that the label is facing upwards. y star ts automatically. y does not star t, press / to select a ack and then press . om USB Note Ensure that the USB device contains playable music. Flip open the cover marked USB DIRECT on the top panel. t the USB plug of a USB device into the exposed socket. USB to select the USB source. Skip to a track / to select another track. To select a track directly, you can also press a key on the numerical keypad. enter a 2 or 3-digit number, press SHIFT, then enter umber. or MP3 disc and USB: PRESET/ALBUM +/-to select an um or folder. / to select select a track or file. Pause/resume play ing play, press to pause/resume ch within a track ing play, press and hold / . Release to resume normal play. y play information DISPLAY repeatedly to see the wing information. The track number and elapsed play time of the current track (if available). Repeat play 1 During play, press REPEAT/ST. repeatedl to select: » [REPEAT] (repeat): play the cur track repeatedly. » [REPEAT ALL] (repeat all): play ...