Stimmen - 4, Durchschnittliche Bewertung: 3.8 ( )

Hersteller: Avanti Dateigröße: 230.74 kb Dateiname: cf211g1.pdf Unterrichtssprache:

· After plugging the appliance into a wall outlet, allow the unit to cool down for 2~3 hours before placing food in the freezer compartment. 7 Electrical Connection .Warning• Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is damaged, have it replaced by an authorized Avanti Products service center. This appliance should be properly grounded for your safety. The power cord of this appliance is equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the possibility of electrical shock. Do not under any circumstances cut or remove the third ground prong from the power cord supplied. This freezer requires a standard 115Volts~/60Hz electrical outlet with three-prong ground. The cord should be secured behind the freezer and not left exposed or dangling to prevent accidental injury. Never unplug the freezer by pulling the power cord. Always grip the plug firmly and pull straight out from the receptacle. Do not use an extension cord with this freezer. If the power cord is too short, have a qualified electrician or service technician install an outlet near the freezer. The “POWER” light indicates that the freezer is properly connected to the electrical power. The light indicates power supply, and will glow even if the temperature control dial is turned to “OFF”, or the compressor has failed to work and the compartment is not being cooled. • Extension Cord Because of potential safety hazards under certain conditions, it is strongly recommended that you do not use an extension cord with this unit. However, if you must use an extension cord it is absolutely necessary that it be a UL/CUL-Listed, 3-wire grounding type appliance extension cord having a grounding type plug and outlet and that the electrical rating of the cord be 115 volts and at least 10 amperes. • SURGE PROTECTOR Most electrical appliances use a series of electric control boards to operate. These boards are very susceptible to power surges and could be damaged or destroyed. If the appliance is going to be used in an area or if your city / country is prone to power surges / outages; it is suggested that you use a power surge protector for all electrical devices / appliances you use. The surge protector that you select must have a surge block high enough to protect the appliance it is connected to. If you have any questions regarding the type and size of surge protector needed contact a licensed electrician in your area. Damages due to power surges are not considered a manufacturer covered defect and will void your product warranty. 8 OPERATING YOUR FREEZER Temperature Control . Your freezer has one control for regulating the temperature. The temperature control is located on the lower right hand corner. . The first time you turn the unit on, turn the temperature control knob in a clockwise direction to the maximum setting "7" and run for at least 2 hours before putting frozen foods inside. This will ensure the cabinet is thoroughly chilled before food is put in. . The range of the temperature control is from position "1" the warmest to "7" the coldest. Adjust the temperature control to the setting that best suits your needs. The setting of “4” should be correct for home or office freezer use. . To turn the freezer off, turn the temperature control to "OFF". NOTE: • Turning the temperature control to "OFF" position stops the cooling cycle but does not shut off the power to the freezer. • If the unit is unplugged, lost power, or turned off; you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the freezer will not start. • Large amounts of food will lower the cooling efficiency of the appliance. • If you choose to change the thermostat setting, adjust thermostat control by one numerical increment at a time. Allow several hours for temperature to stabilize between adjustments. 9 Defrosting Your Freezer . When? For the most efficient operation and minimum energy consumption, defrost the freezer when the frost on the freezer walls is excessive or . to . inch thick. . Choose a time when the stock of frozen food is low. CAUTION Do not use boiling water because it may damage the plastic parts. In addition, never use a sharp or metallic instrument to remove frost as it may damage the cooling coils and will void the warranty. We recommend using the plastic scraper provided with your unit. . Remove the frozen food from the freezer and place it in a cooler to protect the food. . Turn the thermostat knob to “OFF”. . Unplug the freezer.. The Power Supply light should be OFF. . During the defrost process, the ice melts into the cabinet. . Remove the drain plug on the inside floor of the freezer by screwing out. . Place a shallow pan outside drain outlet. The defrost water will drain out. . Check the pan occasionally so the water does not overflow. . Clean the interior of the freezer. . Replace the plug on the inside floor, The Powe...

Herunterladen

Geben Sie zwei Ziffern: