Stimmen - 1, Durchschnittliche Bewertung: 3
(
)
)
|
Anleitung Zusammenfassung
e.g. PROG PROG 2 PROG 1 HI PROG 1 MED MED H. CYCLE COUNTER X To Check The Number Of Cycles That The Oven Has Been Used In Manual Mode: PAD INSTRUCTION DIGITAL DISPLAY WINDOW 1 Open the door and leave it open. The oven lamp will turn on and “0” will appear. 2 STOP/ RESET POWER/ LEVEL While pressing Stop/Reset pad, press Power Level Selector pad. The number of cycles that the oven has been used in manual mode will appear. e.g. - 13 How to Operate How to Operate X To Read The Number Of Times Each Memory Pad Has Been Used: Example: To read tthe number of imes of Number/Memory pad “3” at A side (6666 times used) PAD INSTRUCTION DIGITAL DISPLAY WINDOW 1 Open the door and leave it open. The oven lamp will turn on and “0” will appear. 2 3STOP/ RESET While pressing Stop/Reset pad, press Number/Memory pad “3”. The number of times this Number/Memory pad has been used will appear. e.g. Note: • To read B side. press Shift (A/B) pad while the display is still showing the number of cycles. X To Read Total Cumulative Cycles That The Oven Has Been Used: Close the door while the dispaly is still showing the number of cycles that each pad has been used. The total cumulative cycles that the oven has been used in Number/Memory pads at A/B sides and manual mode will appear. I. AIR FILTER Example: To program cleaning Air Filter every 600 hours PAD INSTRUCTION DIGITAL DISPLAY WINDOW 1 Open the door and leave it open. The oven will turn on and “0” will appear. 2 START While pressing Start pad, close and open the door. 3 3 Press Number/Memory pad “3”. The currently programmed hour will appear. e.g. 4 0 06 Press Number/Memory pads “6”, “0” and “0”. The programmed hour will appear. Note: up to 9999 hours e.g. 5 PROG Press Prog pad. Three seconds later, “0” will appear. Note: When “FILT” sign appears in Digital Display Window, remove Air FIlter and clean it with soapy water. Press Stop/Reset pad to clear the display. To check the total number of hours used, X Open the door and leave it open. X Press Number/Memory pad “3” while pressing Start pad. X The total number of hours used and “H” will appear in Digital Display Window. X e.g. If the oven has been used for 20 hours, Three seconds later, “0” will appear in Digital Display Window. Note: If the oven cuts out after short operation, check if Air Filter is clean before calling for service. - 14 Installation Instructions for StackinInstallation Instructions for Stacking IMPORTANT 1. Disconnect the power cord from the wall socket before attempting installation. 2. For stacking installation, you must use the PANASONIC Joint Plate which is enclosed with this unit. 3. The combination of the units for stacking is limited to only the following PANASONIC models: INSTALLATION NE-1247, NE-1257, NE-1258, NE-1757, NE-2157, NE-DF20G 4. The maximum stacking height is the total heights of two units. PREPARATION Be sure the oven cavity is empty. Be sure surfaces where ovens meet is clean and sanitized. 1. Stack the units and remove five screws (a) as shown in Fig.1. 2. Loosen the screw (b). 3. Projection on Joint Plate must face away from the oven. Place Joint Plate on the screw (b). 4. Attach and tighten five screws (a) and the screw (b). See Fig.2. 5. Ensure the top oven is at a safe and workable height. (b) Joint Plate Projection Joint Plate Projection (a) Fig. 1 Fig. 2 Sanitary Counter Top Seal When microwave oven units are stacked on a counter top, their base must be sealed in accordance with N.S.F. Standards as per the following instructions. 1. Microwave oven should be located on a level counter top surface. Complete the electrical connections. 2. Thoroughly clean the microwave oven bottom perimeter and the counter top area around the microwave oven perimeter. 3. Lay generous bead of silicone seal around the entire perimeter of the base of each microwave oven unit. 4. Smooth the silicone seal into the crevice with finger or tool to provide a cove seal. Note: Remove the Air Filter from the front of the oven before applying silicone. DO NOT FORGET to re-install the Air Filter after applying silicone. Silicone Sealant Counter Top - 15 Care of Your OveCare of Your Oven 1. Remove the plug from the electrical socket before cleaning. 2. Keep the inside of the oven clean. If pieces of food or spilled liquids stick to the oven walls, or between door seal and door surface, they will absorb microwaves and may cause arcing or sparks. Wipe up all spills with a damp cloth. Kitchen detergent or an approved sanitizing solution may be used if the oven gets very dirty. Do not use harsh detergents or abrasives. CLEANING OFTHE SPLATTER SHIELD 1. Hold snap in-snap out side stoppers of splatter shield with both hands and pull them in and down. Then take the splatter shield out of the oven cavity. 2. Rinse splatter shield in soapy water and an approved sanitizing solution. 3. Be sure to replace the shield before using the oven. CAUTION Splatter shield must be in place securely when you use the oven. REPLACEMENT OFTHE ...