Hersteller: Alvin
Dateigröße: 1.09 mb
Dateiname:
|
Anleitung Zusammenfassung
If attaching metal pencil ledge, folded-over edge should be on the underside ( unfinished side ) of tabletop and should point towards back edge of board. Figure 5 Pencil Tray Figure 6 Pencil Ledge Page 7 I ■ If 111111111111111111111111111‘11111111111111111 0" I" 2" 3" 15. Carefully turn base assembly upside down and place on table top (this may require two people ) Be sure that the two threaded inserts near the back edge of the table top align with the attachment holes in the tilt mechanisms "I" and the base is centered left-to-right. The upper cross bar-large "F" should be positioned between the 2 sets of pre-drilled holes. 16. Align table top brackets "M" with the 2 sets of pre-drilled holes. These brackets should straddle and capture the upper cross bar "F". Attach brackets using 5/8" phillips screws "R". "Q". 18. Carefully return assembled table to its upright position (this may require two people). Page 8 I ■ If 111111111111111111111111111‘11111111111111111 0" 1" 2" 3" 19. Snap together the two drawer frame sets "J". This is best done with the drawers removed. Note that sets consist of distinctive top, middle and bottom pieces. ( Middle piece has open top and open bottom. Bottom piece has open top and solid bottom with 4 round feet. Top piece has solid smooth top and open bottom.) TIP: When snapping together, start simultaneously in the two front corners and slowly work your way to the back corners making sure that each tab is aligned before applying pressure. When complete, slightly loosen the alien bolts holding the drawer support hangers "H" and slide each of the drawer units into place. Retighten all drawer support bolts 22. Table assembly is now complete and ready to use. Please save these instructions for future reference. Enjoy! Page 9 To Adjust Tilt The ratcheted tilt mechanisms allow you to set the table top at a variety of comfortable working angles. Simply lift the table top from the back edge until it clicks into the desired position. To return the top to the flat position, raise the back edge as high as it will go. This will release the ratchet mechanism. To Adjust Height It is suggested that the table height be set during initial assembly, prior to attaching drawer units. To adjust the height at a later time, follow these steps: 1. Please do not attempt to adjust the height with the table in the upright position 2. It is suggested that two people perform the height adjustment to avoid damaging table 3. Return table top to flat, horizontal position 4. Remove drawers to avoid spilling contents. (It is ok for drawer unit frames to remain in place) 5. Carefully lay table on its back. Be sure it is resting on a caipeted or otherwise protected surface 6. Unscrew height adjustment knob "K" from both left and right side frames and slide out adjustment rods. Align adjustment holes and desired setting and reinsert rods. Screw adjustment knobs onto ends of rods and return table to upright position. FREE GOODS ...
Dieses Handbuch ist für folgende Modelle:Möbel - CraftMaster CM40-3-WBR (1.09 mb)
Möbel - CraftMaster CM40-4-XB (1.09 mb)