|
Dieses Gerät hat auch andere Anweisungen:
Anleitung Zusammenfassung
1 + DIMM LED J20 : SPDIF (The SPDIF output is capable of providing digital audio to external speakers or compressed AC3 data to an external Dolby digital decoder.) (Optional) 1 Pin No. Definition 1 VCC 2 SPDIF OUT 3 GND 18 Connectors J16 : TEL(The connector is for internal modem card with voiceconnector) 1 Pin No. Definition 1 Signal-In 2 GND 3 GND 4 Signal -Out J14: Wake on LAN 1 Pin No. Definition 1 +5V SB GND2 3 Signal 20 Panel and Jumper Definition JP27 : Back USB Device Wake up Selection(Optional) (USB Connector a CN3) CN3 1 Pin No. Definition USB Device 1-2 close Wake up 2-3 close Normal (Default) (If you want to use "USB KB/Mouse Wake from S3" function, you have to set the BIOS setting "USB KB/Mouse Wake from S3" enabled, and the jumper "JP27" enabled). *(Power on the computer and as soon as memory counting starts, press . You will enter BIOS Setup. Select the item "POWER MANAGEMENT SETUP", then select "USB KB/Mouse Wake from S3: Enabled". Remember to save the setting by pressing "ESC" and choose the "SAVE & EXIT SETUP" option.) JP3 : PS/2 Keyboard Power On Pin No. Definition 1-2 close PS/2 Keyboard Power on Enabled 2-3 close PS/2 Keyboard Power on Disabled (Default) 1 20 Panel and Jumper Definition Panel and Jumper Definition JP32 : Front USB Device Wake up Selection (Optional) (USB Port a CN9) CN9 Pin No. Definition 1 -2 close USB Device Wake Up 2 -3 close Normal (Default) 1 (If you want to use "USB KB/Mouse Wake from S3" function, you have to set the BIOS setting "USB KB/Mouse Wake from S3" enabled, and the jumper "JP32" enabled). *(Power on the computer and as soon as memory counting starts, press . You will enter BIOS Setup. Select the item "POWER MANAGEMENT SETUP", then select "USB KB/Mouse Wake from S3: Enabled". Remember to save the setting by pressing "ESC" and choose the "SAVE & EXIT SETUP" option.) JP33 : FWH Write Protection When you add/update new device, set Jumper JP33 to ”Open”, the need to be enable to update BIOS data. 1 Pin No. Definition close Write Protection open Normal (Default) 26 Suspend to RAM Installation A.3 How to put your system into STR mode? There are two ways to accomplish this: 1. Choose the “Stand by” item in the “Shut Down Windows” area. A. Press the “Start” button and then select “Shut Down” B. Choose the “Stand by” item and press “OK” 32 Suspend to RAM Installation A.5 Notices : 1. In order for STR to function properly, several hardware and software requirements must be satisfied: A. Your ATX power supply must comply with the ATX 2.01 specification (provide more than 720 mA 5V Stand-By current). B. Your SDRAM must be PC-100 compliant. 2. Jumper JP2 is provided to connect to the STR LED in your system chassis. [Your chassis may not provide this feature.] The STR LED will be illuminated when your system is in STR sleep mode. STR LED Connector External. 1 + DIMM LED 36 BIOS Setup GETTING HELP Main Menu The on-line description of the highlighted setup function is displayed at the bottom of the screen. Status Page Setup Menu / Option Page Setup Menu Press F1 to pop up a small help window that describes the appropriate keys to use and the possible selections for the highlighted item. To exit the Help Window press