Stimmen - 3, Durchschnittliche Bewertung: 3.7
(
)
)
|
Anleitung Zusammenfassung
3. Make sure the massage heads are in the retracted position, i.e. they are parked to the left and right in the upper part of the backrest. If not retracted, press twice to return the massage heads to the retracted position. 4. Make sure the legrest is lowered. • Do not sit on the legrest when it is raised. Doing so may cause it to collapse down or bend the legrest. The legrest is not meant to support full body weight. Lowering the Legrest Pull the legrest slide lever, make sure the legrest is fully retracted, then press twice to return the legrest to its lowest position. 10 ADJUSTING THE RECLINING ANGLE 1. Pull on the legrest slide lever and extend the legrest to desired length. (maximum approx. 6 in. (15 cm)). 2. Release the legrest slide lever. EXTENDING THE LEGREST LENGTH ADJUSTING THE SEAT Press and to adjust the angle of the backrest and legrest. • With either button held down, movement will continue until a “beep-beep-beep” sound indicates the legrest or backrest has been raised or lowered as far as possible. • The legrest will start to move shortly after the backrest. Approx. 85° Approx. 120° Approx. 170° Approx. 85° Adjust the pillow height so that the bottom edge of the pillow is at ear level. • If positioned too low, the pillow can lessen the effect of massage around the neck area. ADJUSTING FOR CORRECT PILLOW HEIGHT Fasteners • Extend legrest length by pushing legrest slide projection with heel. • Raise legs slightly and legrest returns. • Extend until the end of the legrest is lower than the knees. Legrest Slide Lever Pull back. Release the lever. USING PRE-PROGRAMS AND QUICK MASSAG E 1. Press the OFF/ON button. • The OFF/ON indicator will come on. 1 Press • You can now select one of the pre-programs or one of the manual settings. 2. Select the pre-program you want. • Please press one of the flashing buttons. • For a general explanation of pre-program characteristics, please refer to the bottom of this page. • For an outline of each pre-program, please refer to the information on page 18. • If you press another Pre-Program button during your selected pre2 program massage, the massage will switch to the newly selected pre-program. 5 The Selected Program will Start • It is possible to change the pre-program selected or to change to manual operation mid-way through a massage. • In pre-programs, the leg massage begins at the same time. It is possible to stop or change the intensity of the leg massage during the program. (See Page 17) 4 3. Sit as far back in the seat as possible with your head on the pillow. • Pressing a Pre-Program button automatically moves the backrest and legrest into massage position. • If the massage lounger is reclined further than this angle then it will not automatically recline. Head rests on pillow. About the Time Indicator Time Remaining Approx. 15 min. Approx. 9 min. Approx. 3 min. Pre-Program and Quick Massage Characteristics • Displays remaining massage time via flashing LED. • Starts counting down from 15 minutes in increments of approximately 3 minutes. • Flashing speeds up one minute before end of massage. Shiatsu: Uses mainly Soft Shiatsu, Tap and Knead actions to comfortably loosen and provide relief from tension held at pressure points. Recommended for those with severe stiffness or who prefer a stimulating massage. Swedish: Uses mainly Swedish, Hawaiian and Knead actions to evenly apply muscle-relaxing strokes all over. Recommended for those who are just starting out or prefer a gentle massage. Stretch: Uses mainly Full Roll, Soft Shiatsu, Compression, Knead and Leg Stretch actions to stretch out and loosen up back and leg muscles. Recommended for those who are physically inactive or troubled by tired legs. Quick: Covers all areas using a variety of massage actions, all in a span of just five minutes. Recommended for those who want to relax quickly. 4. 4. • When a pre-program begins, the backrest and legrest automatically move the massage position where the massage heads carry out a Soft Shiatsu massage in the area around the shoulders. During the time that the shoulder position indicator is flashing (approx. 7 seconds), use the Neck Roller Position button to align the position of the massage heads to your shoulder height. Approximate positions for adjusting the position of the heads are shown below. Up Down Approximate Height • It is possible to change the position of Press Press the massage heads during the massage. 6'1" (185 cm) 5'2" (160 cm) 4'6" (140 cm) • 5-stage adjustment • Lightly touchingthe shoulder. Too high Correct position Too low Helpful Tips • When the shoulder position indicator is flashing, adjust the position of the massage heads (upper heads) so that they lightly touch the shoulders. • The shoulder position can be adjusted up and down 4 in. (10 cm). • When it is not possible to correctly adjust the shoulder position, you may have to slide your body and adjust it again. • Persons whose height is less than 4.6 ft. (140 cm) or more than 6.1 ft....