Stimmen - 6, Durchschnittliche Bewertung: 3.8
(
)
)
|
Anleitung Zusammenfassung
Move the chair by having one person hold onto the rubber section on the underside of the legrest and another person use the handle on the back of the backrest. 8 Mat Handle Place your fingers in the groove. Legrest Rubber Section CAUTION • Make certain the legrest has been retracted fully to its original length. Failure to observe this safeguard could result in injury due to the legrest returning to its original length when the unit is being moved. • Use care to prevent pinching of hands or feet when letting go of the legrest as its mechanism will cause it to slam shut. • Use care to prevent lower back and other injuries that could occur when lifting this heavy object (approx. 179 lbs (81 kg)). 11 22 Attachment Screw (M6#16) Allen Key Use This Screw #6 ASSEMBLY Attaching the Armrests (On Both Right and Left Sides) 1. Insert the armrest into the unit. • Markings indicating left-hand and right-hand sides can be found on the inside surface of each armrest. • Make sure the control panel cord does not become pinched when fitting the right armrest onto the unit. 2. Fasten the armrest with the attachment screws. • Set the three attachment screws in place first and then tighten them firmly. Use the mark as a guide for insertion. Turn screws clockwise to tighten. 11 22 Attachment Screw (M6#16) Allen Key Use This Screw #6 ASSEMBLY Attaching the Armrests (On Both Right and Left Sides) 1. Insert the armrest into the unit. • Markings indicating left-hand and right-hand sides can be found on the inside surface of each armrest. • Make sure the control panel cord does not become pinched when fitting the right armrest onto the unit. 2. Fasten the armrest with the attachment screws. • Set the three attachment screws in place first and then tighten them firmly. Use the mark as a guide for insertion. Turn screws clockwise to tighten. Connecting the Air Plugs (On Both Right and Left Sides) Allen Key Attachment Screw (M5#16) Plug Cover Air Plug 1 2 1. Insert the air plug. • Push on the air plug until you hear it click into place. 2. Place the plug cover over top of the air plug and fasten with the screw. Use This Screw #2 Attaching the Control Panel Stand to the Right or Left Armrest Attachment Screw (M6#10) Allen Key • Diagram shows attachment to right armrest. 12 1. Decide which side to attach the control panel stand to. 2. Fasten the control panel stand with the attachment screws in four places. • Set the four attachment screws in place first and then tighten them firmly. Use This Screw #4 Attaching the Control Panel Stand Covers (On Both Right and Left Sides) 1 2 Bottom Tabs Top Tabs Notches The method of attaching the covers is the same for both sides. • Diagram shows side attached with control panel stand. 1. Insert the bottom tabs on the cover into the notches on the armrest. 2. Insert the top tabs on the cover into the notches on the armrest. Cover for Side WITH Control Panel Stand Cover for Side WITHOUT Control Panel Stand (1) Insert the head of a flat-tip screwdriver between the top tabs of the cover. • Performing this procedure with the Allen key or a cross-point screwdriver could damage the unit. When Removing the Control Panel Stand Covers (1) (2) (3) (2) Pull out the top tabs of the cover (two places) using the flat-tip screwdriver. (3) Pull up on the cover at an angle. Attaching the Pillow Use the pillow fasteners to attach the pillow. Raising the Backrest to the Upright Position 1 32 1. Insert the power plug into the power outlet. 2. Insert the key and turn the key lock to the “open” position. 3. Slide the power switch to the “on” position. 4. Press on the control panel twice. • The backrest will rise to the upright position automatically. Moving the Control Panel Cord to the Left Side (When Control Panel Stand is on Left Side) 1 · 2 3 4 Clips for Fastening Control Panel Cord 1. Press on the control panel to turn on the power. ottoman 2. Press on the control panel and hold until the legrest has risen as far as it will go. • Continue pressing until a “beep-beep-beep” sound is heard. 3. Move the control panel cord under the legrest to the left side. 4. Fasten the control panel cord at three points. Placing the Control Panel into the Control Panel Stand 3321 To remove the control panel, slide it upwards. For smooth removal of the control panel, press on the back of the unit while sliding up. 1. Insert the control panel at an angle into the tabs on the control panel stand. 2. Push the control panel into the control panel stand. 3. Fasten the control panel cord using the clip. BEFORE SITTING DOWN Please Check the Following Before Using the Unit Check the Surrounding Area (1) Check that there is nothing around the unit. (2) Check that there is enough room (15.7 in. (40 cm)) to recline the unit. Lower the Legrest Prior to Sitting Down • Do not sit down when the legrest is raised. Doing so may result in injury due to the chair tipping over. To lower the legrest… Pull the legrest slide lever, make sure the legrest is full...