Stimmen - 3, Durchschnittliche Bewertung: 3.3
(
)
)
|
Anleitung Zusammenfassung
USING THE BELT CLIP The belt clip lets you keep your hands free while you listen to the SCP-86. To attach the belt clip to the SCP-86, slide the belt clip’s latches into the slots on the cassette player and slide it up until it locks into place. To remove the belt clip from the SCP-86, push in on PUSH RELEASE, slide the belt clip down, then lift it off. 12 14-1227.fm Page 13 Friday, July 2, 1999 4:20 PM OPERATION PLAYING THE RADIO 1. Set TAPE/RADIO to RADIO. The OPE/BATT indicator lights. 2. Set FM ST/FM/AM to the desired band. Set it to FM ST for stereo sound on FM stations. Notes: • For the best FM reception, fully uncoil the headphones’ or speaker’s cord. • The AM antenna is built-in. Move the SCP-86 to improve AM reception. • To improve reception for weak FM stereo stations, set FM ST/FM/AM to FM. The sound will be monaural, but reception should improve. 3. Rotate TUNING to select a radio station. 4. Adjust VOLUME to the desired listening level. 13 14-1227.fm Page 14 Friday, July 2, 1999 4:20 PM 5. To increase bass sounds, slide E-BASS upwards. 6. To turn off the radio, set TAPE/RADIO to TAPE. PLAYING A CASSETTE TAPE 1. Gently pull open the cassette compartment door and insert a pre-recorded cassette into the guides with the exposed tape edge facing out. Then close the door. 2. Set TAPE/RADIO to TAPE. 14 14-1227.fm Page 15 Friday, July 2, 1999 4:20 PM 3. Set the tape select switch to NORM for normal bias cassette tapes or to CrO2/METAL for chrome or metal cassette tapes. 4. Slide DOLBY NR upwards if you are playing a cassette tape that was recorded with Dolby B noise reduction (see “Dolby Noise Reduction” on Page 18). 15 14-1227.fm Page 16 Friday, July 2, 1999 4:20 PM 5. Set the reverse mode switch to the desired position. One-Time Playback ( the tape, then stops. Continuous Playback ( ) plays both sides of ) alternately plays each side of the tape until you press STOP. 6. Press PLAY. The OPE/BATT indicator lights and the tape begins to play. 7. Adjust VOLUME to the desired listening level. 8. To increase bass sound, slide E-BASS upwards. 9. To stop the tape, press STOP. 16 14-1227.fm Page 17 Friday, July 2, 1999 4:20 PM USING FAST FORWARD AND REWIND When the tape is stopped, press or to rewind or fast-forward it. To stop the tape before it reaches the end, press STOP. Tape Direction Press to Fast-Forward Press to Rewind FWD (Forward) REV (Backward) Note: To protect the tape after the tape has fully wound to either end, press STOP to release the or button. 17 14-1227.fm Page 18 Friday, July 2, 1999 4:20 PM CHANGING THE TAPE DIRECTION You can change the tape’s direction using the FWD/ REV switch. To listen to the tape’s forward side (facing out), set the switch to FWD. To listen to the tape’s reverse side (facing in), set the switch to REV. DOLBY NOISE REDUCTION Your cassette player uses the Dolby B Noise-Reduction system to reduce background noise or tape hiss on your tapes. When a Dolby-encoded tape is recorded, the Dolby circuit listens to the program material to find soft passages where you might later be able to hear the tape noise. The Dolby NR system increases the recording level during these passages. When you play the tape, the circuit reduces the volume of these passages to their original levels and reduces the level of tape hiss to as little as one-third of the usual noise level. 18 14-1227.fm Page 19 Friday, July 2, 1999 4:20 PM TAPE TIPS The following tips can help you get the best performance and the longest life from your SCP-86. Note: For the best performance, use only regular length (60-or 90-minute) cassette tapes. Long- playing cassette tapes, such as C-120s, are not recommended because they are extremely thin and can tangle easily. RESTORING TAPE TENSION AND SOUND QUALITY After you play a cassette tape several times, the tape might become tightly wound on the reels. This can cause playback sound quality to deteriorate. To restore the sound quality, fast-forward the tape from the beginning to the end of one side, then completely rewind it. Then loosen the tape reels by gently tapping each side of the cassette’s outer shell on a flat surface. Caution: Be careful not to damage the cassette when tapping it. Do not touch the exposed tape or allow any sharp objects near the cassette. 19 14-1227.fm Page 20 Friday, July 2, 1999 4:20 PM CLEANING THE TAPE-HANDLING PARTS Dirt, dust, or particles of the tape’s coating can accumulate on the tape heads and other parts the tape touches. This can greatly reduce the performance of the SCP-86. You should clean the tape-handling parts after about every 20 hours of tape player operation. Your local RadioShack store sells a complete line of cassette deck cleaning supplies. 1. Remove the batteries and disconnect any other power source. 2. Open the cassette compartment cover. 3. Press PLAY to expose the tape-handling parts. 4. Use a cotton swab dipped in denatured alcohol or tape head cleaning solution to clean the playback head, pinch rollers, tape guides,...