Stimmen - 3, Durchschnittliche Bewertung: 4.7 ( )

Hersteller: Optimus Dateigröße: 925.67 kb Dateiname: Unterrichtssprache:

You can also connect an external or pillow-type speaker (not supplied) to this jack. Note: Your local RadioShack store sells a wide variety of speakers. Insert the earphone or speaker’s 1/8-inch (3.5-mm) plug into the EAR jack. This automatically disconnects the internal speaker. EAR Listening Safely To protect your hearing, follow these guidelines when you use the earphone. • Do not listen at extremely high volume levels. Extended high-volume listening can lead to permanent hearing loss. • Set the volume to its lowest level before you begin listening. After you put on the earphone, adjust the volume to a comfortable listening level. 10 14-1121.fm Page 11 Thursday, July 1, 1999 2:42 PM • Do not increase the volume once you have established a comfortable listening level. Over time, your ears adapt to the volume level, so a volume level that does not cause discomfort might still damage your hearing. Traffic Safety Do not wear the earphone while operating a motor vehicle or riding a bicycle. This can create a traffic hazard and could be illegal in some areas. Even though some earphones let you hear some outside sounds when listening at normal volume levels, they still can present a traffic hazard. 11 12 PLAYING A CASSETTE TAPE 1. Gently pull open the cassette compartment door. 2. Use your finger or a pencil to turn the cassette’s hub and take up any slack in the tape. Do not touch the tape. 3. Load a cassette into the door’s guides so the cassette’s open edge is out and the side you want to play faces the compartment’s window, then close the door. 4. Set TAPE SPEED to SLOW, NORMAL, or FAST to suit your listening preference. TAPE SPEED NORMAL SLOW FAST 14-1121.fm Page 12 Thursday, July 1, 1999 2:42 PM 14-1121.fm Page 13 Thursday, July 1, 1999 2:42 PM Note: This switch’s setting has no effect when recording (see “Recording” on Page 17). 5. Rotate VOLUME/VOX SENS counterclockwise to its lowest setting. 6. Press PLAY . The tape begins to play. PLAY 7. Adjust VOLUME/VOX SENS to a comfortable listening level. 13 14-1121.fm Page 14 Thursday, July 1, 1999 2:42 PM 8. Set VOX/TONE to HIGH to emphasize treble sounds, or to LOW to reduce them. With metal/High-Bias tape, use LOW for a more natural sound. VOX/ TONE LOW HIGH OUT IN 9. The CTR-115 automatically stops at the end of the tape. Or, press STOP to stop the tape. STOP Notes: • To momentarily stop play, slide PAUSE to ON. Slide PAUSE to OFF to resume playing. 14 OFF ON PAUSE 14-1121.fm Page 15 Thursday, July 1, 1999 2:42 PM OFF ON PAUSE 14-1121.fm Page 15 Thursday, July 1, 1999 2:42 PM • To rapidly advance or rewind the tape, press FAST-F/ CUE or REWIND/REV . The button locks down and the tape continues moving until you press STOP. The TAPE SPEED setting affects the fast-forward or rewind speed. FAST-F/CUE REWIND/REV • The CTR-115 does not automatically stop when it reaches the end of the tape during fast-forward or rewind. To prevent damage to the tape after it has fully wound to either end, press STOP to release fast-forward or rewind. • If you press FAST-F/CUE or REWIND/REV while the tape plays, you hear the tape playing at high speed. This can help you locate a specific portion of the tape. 15 14-1121.fm Page 16 Thursday, July 1, 1999 2:42 PM USING THE TAPE COUNTER You can use the tape counter to give you an indication of the tape’s position. Before playing a tape, press the tape counter reset button to set the counter to 000. 00 0 TAPE COUNTER RESET When the recorder plays, the numbers advance to show the amount of tape that has moved past the tape heads since the tape began moving. When the tape rewinds, the numbers decrease. 16 14-1121.fm Page 17 Thursday, July 1, 1999 2:42 PM RECORDING Note: For the best performance, use only regular length (60- or 90-minute) cassette tapes. We do not recommend long-playing cassette tapes, such as C-120s, because they are extremely thin and can tangle easily. USING THE BUILT-IN MICROPHONE You can pop up the built-in microphone to direct it to the sound source, or you can connect an external microphone (see “Using an External Microphone” on Page 21). Follow these steps to use the built-in microphone. 1. Slide MIC POP-UP in the direction of the arrow marked under the microphone. 2. Slide MIC SENSITIVITY to LOW, MEDIUM or HIGH, depending on the sound source you want to record. For normal recording conditions, set the switch to MEDIUM. If the sound source is weak, slide it to HIGH. For a strong sound source, slide it to LOW. 3. To return the microphone to its original position, gently press it down until it locks into place. 17 MIC POP-UP 14-1121.fm Page 18 Thursday, July 1, 1999 2:42 PM VOX RECORDING When you select VOX recording, the CTR-115 automatically begins recording when it receives a sound signal from a voice or other sound, and automatically stops when the sound stops. For the best recording quality, place the recorder about 1 foot from the sound source. Because the microphone is so sensitive, it will also pick up a voi...

Herunterladen

Geben Sie zwei Ziffern: