Stimmen - 1, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
For optimum performance and safety, please read these instructions carefully. (For areas except Australia and N.Z.) CAUTION: The AC voltage is different according to the area. Be sure to set the proper voltage in your area before use. (For details, please refer to the page 5.) Before use Suggestions for safety........................... 3 Front panel Controls.............................. 4 Connections....................................... 5 Playback_ Playback............................................ 6 Reverse function...................................... 7 About the automatic-tape-select function................ About the remote control function...................... About the Dolby noise-reduction system................. About the Dolby HX-Pro headroom extension system..... Series playback........................................................................8 Tape counter (Deck 2 only). ........................................8 To reset the tape counter............................................................8 To fast'forward or rewind the tape..........................9 To cue or review......................................................................9 Recording_ Recording (Deck 2 only)..........................10 To make a silent interval.....•.......................... 11 Tape-to-tape recording...........................12 To record selected tracks.............................. 13 To cut unwanted parts during recording................. 13 Reference Concerning cassette tapes......................14 Maintenance.......................................15 Technical specifications.........................15 Troubleshooting guide............... Back cover Placement Foreign materials Avoid placing the unit in areas of: • direct sunlight • high temperature • high humidity • excessive vibration • uneven surfaces. (Place the unit on a flat level surface). Such conditions might damage the cabinet and/or other component parts and thereby shorten the unit's service life. Ventilation Place the unit in a well ventilated position at least 10 cm away from wall surfaces etc. Stacking Never place heavy items on top of the unit or the power cord. Voltage • It Is very dangerous to use an AC power source of high voltage such as for an air conditioner. A fire might be caused by such a connection. • A DC power source cannot be used. Be sure to check the power source carefully, especially on a ship or other place where DC is used. Power cord protection • Avoid cuts, scratches or poor connection of the AC mains cord, as this may result in fire or electric shock hazard. Excessive bending, pulling or slicing of the cord should also be avoided. • Do not pull on the cord when you are disconnecting the power, as this could cause an electric shock. Grasp the plug firmly when you disconnect the power supply. • Never touch the plug with wet hands or a serious electric shock could result. • Ensure that no foreign objects, such as needles, coins, screwdrivers etc, accidentally fall into the unit or through the ventilation holes. Otherwise, a serious electric shock or malfunction could occur. • Be extremely careful about spilling water or liquid on/into the unit, as a fire or electric shock could occur. (Disconnect the power plug and contact your dealer immediately if this occurs.) • Avoid spraying insecticides onto the unit as they contain flammable gases which can be ignited. • Insecticides, alcohol, paint thinner and similar chemicals should never be used to clean the unit as they can cause flaking or cloudiness to the cabinet finish. Maintenance (See page 15.) Clean the cabinet, panel and controls with a soft cloth lightly moistened with mild detergent solution. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine. Service • Never attempt to repair, disassemble or reconstruct the unit if there seems to be a problem. A serious electric shock could result if you ignore this precautionary measure. • If a problem occurs during operation (the sound is interrupted, indicators fail to illuminate, smoke is detected, etc) contact your dealer or Authorised Service Center immediately. • Disconnect the power supply if the unit will not be used for a long time. Otherwise the operation life could be shortened. -fi,*;,;!■■■,%&.* * l"*" ^ ^ ” v * ' " ■ : V - '-ï 1 \ - \ ^ m ; l *1. " ■ ” \ ■ % ■' \ J \ ^ ^ i'w„v" - - •..* '*■£>: -:^.,. :v ; ;v;:,:».\ a, ^ - =;■: /£:;r ' --* No. Name Ref. page (D Power “A STANDBY 6 ON” switch (POWER, A STANDBY (!) ^ ON) 6 Press to switch the unit from on to standby mode or vice versa. In standby mode, the unit is still consuming a small amount of power. (2) Remote control signal receptor - (Refer to “About the remote control function" on page 7.) ® Cassette holder - @ Eject button (EJECT) 6 © Display — (§) Recording-level control (REC LEVEL) 10 ® Reverse-side playback button (^ PLAY) 6 (...