Stimmen - 2, Durchschnittliche Bewertung: 5 ( )

Hersteller: Attwood Dateigröße: 503.45 kb Dateiname: Unterrichtssprache:

Mount the anti-glare light in a position so that: • Light output is flat and parallel to water when boat is floating. • Light shines 360°, unobstructed. • Light does not shine on operator, or reflect off any part of the boat in the operator’s field of vision. Figure 1 7.5° or 39-3/8" One meter INSTALLATION Figure 2 Base #911339, 911370, or 911445 Pole Screw • Poles Without Locking Collar (5300 Series) 1. Align pole screw with slot in the existing base. Insert pole into base (Figure 2). 2. Press down firmly to engage electrical connectors. 3. To remove, pull straight up. Poles With Locking Collar (5310, 5320, 5330 Series) 1. Align pole screw with slot in the existing base. Insert pole into base (Figure 3). 2. Press down firmly to engage electrical connectors. 3. Slide locking collar down to base, rotate until you can insert lower ring inside top of base. 4. Press collar down into base and rotate until it tightens between pole and base. NOTE: Periodically check pole to make sure it is secure. loosens, then pull up on pole. (Figure 3) Figure 3 Locking Collar • Lower Ring • #91020, #91024, Screw • or #91026 #91022 TO CONVERT POLE FOR USE WITHOUT LOCKING COLLAR 1. For bases that do not accept locking collar, remove screw at bottom of pole. Slide locking collar off end of pole. 2. Replace screw in the upper screw hole. TO ADJUST ANTI-GLARE ARTICULATING HEAD (5330 Series) For best glare reduction, adjust the light while the boat is floating, or at the same attitude as if it were floating. 1. Unscrew lens counter-clockwise and remove. Remove bulb (Figure 4) 2. Remove the pivot screw. Pull the top pivot up and away from yoke. Place a small level on top of the socket and rotate to level position. 3. When it is level, push yoke and pivot back together. Replace and tighten screw. (Do not over tighten.) Replace bulb. Figure 4 Lens Off On Bulb #906 Pivot Screw OPERATION After installation, check lights to verify proper operation. Regulations require lights to be operated with a three-position switch for: • Running lights (sidelights and all-round light); Anchor lights (all-round light only); Off. NOTE: Do not use light pole as a flagpole or handle. MAINTENANCE When not in use, store in Pole Light Storage Clips (Attwood 7571). Choose a storage location where light will not be damaged or be in constant contact with water. Replacing Bulb 1. Unscrew lens counter-clockwise and remove. Pull bulb straight up (Figure 4) 2. Replace bulb with #906 9-Watt Wedge Base Replacement Bulb (Attwood 9235-7) available in marine, auto, and convenience stores. 3. Screw lens clockwise onto pole. 4. If lens requires replacement, order Attwood #912852. Clean the light with a mild soap and warm water solution. Never use solvents or abrasives that may damage the lens or light housing. © 2003 Attwood Corporation 1016 N. Monroe Street, Lowell, MI 49331-0260 3. Faites glisser le collier jusqu’a la base ; tournez jusqu’a ce que vous 3® Feu d’horizon antireflet Serie 53...

Herunterladen

Geben Sie zwei Ziffern: