Login:
Stimmen - 2, Durchschnittliche Bewertung: 3.5 ( )

Anleitung Tanaka, modell TOB-120

Hersteller: Tanaka
Dateigröße: 407.92 kb
Dateiname:
Unterrichtssprache:en
Link zum kostenlosen Download Hinweise finden Sie am Ende der Seite



Anleitung Zusammenfassung


Always use branded 89 octane unleaded gasoline. NOTE: After fuel mixture has been left standing for a prolonged period of time it will begin to separate, therefore thoroughly shake mixture before using. Mounting To Boat Motor must be mounted in center of boat transom. Recommended transom height is 20". Clamp to transom with clamp stud handles turned hand tight. Secure unit to transom using a safety chain (not supplied). During operation, occasionally check clamps for tightness. Loose clamps may result in damage to motor or boat. 7 custsvc@tanaka-ism.com TOB-120,TOB-300 Owner.s Manual Tilt Adjustment Motor tilt must be adjusted to propel boat through the water with an even keel. If the motor is tilted too far outward, bow of the boat would ride too high in the water obscuring the operator's view and be susceptible to sudden movement by high winds and waves. If the motor is tilted too far inward, the bow may dig into high waves or wakes. A 12 to 15 degree tilt is recommended. This angle may need to be adjusted according to the weight of boat and passengers. Improper transom height or tilt angle may result in boat "porpoising" or motor cavitation. Boat porpoising is a condition where the bow of the boat raises and falls rapidly and continuously. Motor cavitation is a condition where turbulent air passes by the propeller resulting in an increase in motor speed coupled with a rapid drop in boat speed. These conditions can also be caused by fast turns, rough water, wrong or obstructed propeller, or poor boat design. To adjust, stop motor and allow propeller to come to a full stop. Tilt motor all the way up to the storage position, then remove Tilt Lock Bracket Pin. Re-position lock pin in one of five angle adjustment holes in clamp bracket. Secure Tilt Lock Pin with Hair Pin. To determine the best motor tilt angle, start with the Tilt Lock Adjustment Pin in the center set of holes. In calm water, operate boat at full throttle with a normal load. Adjust tilt angle as necessary to establish a near even keel. Steering Adjustment The amount of resistance to movement of the steering handle is adjustable. Loosen or tighten the steering tension bolt using an open end spanner wrench (supplied). IMPORTANT: The tension bolt may fall out if loosened much. too 8 custsvc@tanaka-ism.com Owner.s ManualTOB-120,TOB-300 TOB-120,TOB-300 STARTING CAUTION: DO NOT attempt to start motor at this time. Familiarize yourself with controls to see what they do, how they work and thoroughly read and understand entire Owner's manual first. WARNING: Insure all guards and safety devices are installed and working properly before starting. WARNING: Rotating propeller can cause serious Injury. Be sure propeller is clear of swimmers, waders, or underwater objects because when Throttle is set at starting position motor speed will be fast enough for clutch to engage and propeller to rotate. Fuel When starting motor, open Air Vent Screw on Fuel Filler Cap. Open Fuel Shut Off Valve. Choke If starting a cold motor, move Choke Lever to its START (ON) position. After motor begins to fire, move choke lever to its RUN (OFF) position. IMPORTANT: Continued over choking while engine is running may cause spark plug to foul. Flooding is a condition where motor will not start due to an overabundance of fuel in crankcase. If flooding occurs, move choke lever to RUN position, set throttle at half and pull rewind starter handle until engine starts and continues to run. Throttle Lever Model 120 Move Throttle lever to a half open position. Model 300 Move twist grip handle to half throttle position. WARNING: Starting motor may Immediately engage propeller clutch resulting In a sudden movement of the boat. Be sure all passengers are seated before starting motor. NOTE: Allow motor to warm up at idle speed for 2 to 3 minutes before applying load. WARNING: After motor Is started and Is Idling smoothly, propeller must not rotate. A rotating propeller can cause severe personal Injury. See Adjustment Section for Carburetor Adjustment. 9 custsvc@tanaka-ism.com TOB-120,TOB-300 Owner.s Manual Rewind Starter Grasp Rewind Starter handle and pull rope slowly until you feel some resistance, then pull rope with a rapid stroke and allow rope to rewind slowly. Repeat above instructions until motor starts. CAUTION: Never start motor at full throttle or stand up while starting motor. WARNING: When motor starts, propeller may start to rotate at a high rate of speed. Reduce Throttle speed Immediately. Failure to do so may result In loss of control of the boat and may cause severe personal Injury. IMPORTANT: Do not release starter rope and let it snap back against housing. STOPPING For normal stopping, move Throttle Lever or twist grip to IDLE position and allow motor to run at idle speed for a few minutes so that motor parts can cool evenly. To shut off, move Throttle Lever to full OFF position. For mode...

Dieses Handbuch ist für folgende Modelle:
Boote Zubehör - TOB-300 (407.92 kb)

Bewertungen



Bewerten
Vorname:
Geben Sie zwei Ziffern:
capcha





Kategorien