Stimmen - 2, Durchschnittliche Bewertung: 4.5 ( )

Hersteller: Oricom Dateigröße: 1.7 mb Dateiname: UHF100.pdf Unterrichtssprache:

In Australia the ACMA Radio communications (Citizen Band Radio Stations) and in New Zealand by MED General User Radio License for Citizen Band Radio and operation is subject to conditions contained in those licences. Safety Information and Warnings Potentially Explosive Atmospheres WARNING Turn your radio OFF when in any area with a potentially explosive atmosphere. Sparks in such areas could cause an explosion or fire resulting in injury or even death. NOTE: Areas with potentially explosive atmospheres are often, but not always clearly marked. They include fueling areas such as below deck on boats; fuel or chemical transfer or storage facilities; areas where the air contains chemicals or particles, such as grain, dust, or metal powders; and any other area where you would normally be advised to turn off your vehicle engine. Blasting Caps and Areas To avoid possible interference with blasting operations, turn your radio OFF near electrical blasting caps or in a “blasting area” or in areas posted: “Turn off two way radios.” Obey all signs and instructions. Electromagnetic Interference/Compatibility Nearly every electronic device is susceptible to electromagnetic interference (EMI). To avoid the possibility of electromagnetic interference and/or compatibility conflicts, turn off your radio in any location where posted notices instruct you to do so such as health care facilities. Controls and Connectors Box Contents UHF100 1 x RF Radio 1 x Remote Head Unit with 2m cable 1 x UHF100 Standard Microphone 1 x DC Power Cord with inline fuse 1 x Mounting bracket with mounting screws for RF Radio UHF200 1 x RF Radio 1 x Controller Speaker Micrphone 1 x DC Power Cord with inline fuse 1 x Mounting bracket with mounting screws for RF Radio 1 x Mount bracket with mounting screw for Remote Head Unit 1 x Microphone Hanger 1 x User Guide 1 x Microphone Hanger 1 x 2m long Extention cable 1 x Coupler for extention cable 1 x User Guide Controls and Connectors Front View Remote Head unit (UHF100) 1 23 45678 1. Microphone connector 2. LCD Display 3. Power On/Off, channel & Volume control 4. Function button by short push & Duplex On/Off by long push 5. Open Scan, Memory On/Off, Group Scan 6. Priority Channel On/Off, Key Lock On/Off, Alpha-numeric display 7. ID setting, 5 tone SelCall, Quiet 8. Monitor, TSQ On/Off, Menu 9. External speaker Jack (3.5mm for optional 8 ohm speaker) Controls and Connectors Rear View Rear view of Radio (UHF100 & 200) 1. 3.5mm external jack for optional 8 ohm speaker 2. Power Supply connection 3. Antenna connection 3 2 1 Standard Microphone (UHF100) 1. Push To Talk (PTT) button 2. Volume Up, Channel Up 3. Volume Down, Channel Down 4. Power On/off, Volume and channel selector 34 2 1 8 Controls and Connectors Top view of Contoller Speaker Microphone (UHF200) 1. Volume Down, Channel Down 2. Volume Up, Channel Up 3. Power On/Off Front view of Contoller Speaker Microphone (UHF200) 4. LCD Display 5. Function button & Duplex On/Off 6. Open Scan, Memory On/Off, Group Scan 7. Priority Channel On/Off, Key Lock On/Off, Alpha-numeric display 8. ID setting, 5 tone Selcal, Quiet 9. Monitor, TSQ On/Off, Menu 10. PTT Switch 1 3 2 200RX CH 4 9 10 8 7 6 5 Controls and Connectors LCD Icons & Indicators (UHF100 and UHF200) 1 2345618 78 9 16 10 11 12 13 1. FUNCTION 2. RX or TX Signal strength 3. Transmitter Indicator 4. Receiver Indicator 5. Quiet mode 6. Priority On/Off 7. Monitor On/Off 8. Memory On/Off 9. Key Lock 17 1514 10. Open Scan 11. Group Scan 12. Selelctive call Sending_to 13. Selective call Receiving from 14. 38 CTCSS Tone On/Off 15. DCS On/Off 16. Channel number 17. ALPHA/NUMERIC 18. Call Alarm 10 Installation INSTALLATION CAUTION When installing your radio in your vehicle, check that during installation you do not damage any wiring or vehicle components that may be hidden around the mounting position. If you are unsure about how to install your radio, we suggest for optimum performance you have your radio professionally installed by a UHF specialist or Auto electrician. When installing the radio, avoid mounting it close to heaters or air conditioners. Do not press the PTT or CALL button before installing the antenna. Screw the mounting bracket and the remote head bracket to firm surfaces. To install the Radio; 1. Fix the radio bracket in a suitable location. 2. Then fix the radio in the bracket using the thumb screws. Note The radio contains a built-in loud speaker, The radio can be installed ‘out of the way’ and an external speaker can be used as an alternative (not supplied). To mount the Remote Head (UHF100) The remote head is supplied with a slim mounting bracket and thumb screws. Its small size and light weight design allows it to be mounted in almost any convenient position accessible to the driver. 11 1. Fix the mounting bracket in place by screwing through the slots in the bracket. 2. Fix the remote head unit to the mounting bracket with the thumb screws provided. 3. Connect the standard microphone to th...

Herunterladen

Geben Sie zwei Ziffern: