Stimmen - 3, Durchschnittliche Bewertung: 4 ( )

Hersteller: Black & Decker Dateigröße: 309.8 kb Dateiname: 20091210-150547-ASTE-6ZHP5K_R0_EN.pdf Unterrichtssprache:

NOTE: Small sparks may occur during battery connection. This is normal. TURN the Back-UPS over, and slide the battery compartment cover off ofthe battery housing. 1 2 3REMOVE the battery from the battery compartment, and connect the black wireto the negative (-) battery terminal. Ensure the battery is installed as shown below. INSTALL the battery compartment cover back onto the battery housing. Place the Back-UPS to avoid: - Direct sunlight - Excessive heat - Excessive humidity or contact with fluids Plug the Back-UPS power cord directly into a wall outlet, and not to a surge protector or power strip. The wall outlet should be located near the equipment, and easily accessible. Power On Power Switch UPS Status Indicator (Green - OK, Red or Amber- See User Manual) Power On 2Surge Protection Only These outlets provide full-time protection from surges even if the Back-UPS is switched OFF. Plug your printer, fax machine, scanner, or other peripherals that do not need battery power intothese outlets. Battery Backup Surge Protection These outlets are powered whenever the Back-UPS is switched ON. During a power outage, or other utility problems (brownouts, over-voltages), these outlets will be powered for a limited time by the Back-UPS. Plug your computer, monitor, and two other data- sensitive devices (external disk or tape drive) into these outlets. 3APC, Back-UPS and PowerChute are registered trademarks of American Power Conversion Corp. Power On Press the ON/OFF switch to power the unit ON. A single short beep, and the green “Power On” indicator confirms that the Back-UPS is on and ready to provide protection. The Back-UPS should charge for at least 24 hours to ensure sufficient runtime. The unit is being charged whenever it is connected to utility power, whether the unit is turned ON or OFF. The Back-UPS ES indicates its operating status using a combination of visual and audible indicators. Use the following table to identify the status of the Back-UPS ES. Visual Indications (Power On - Green) (Replace Battery - Red) Audible Indication (Buzzer) Condition GREEN On Off Power On - Back-UPS is supplying conditioned utility power to the connected equipment. GREEN On (Off during 4 beeps) 4 beeps repeated every 30 seconds On-Battery - Back-UPS is supplying battery power to the load connected to the Battery outlets. Flashing GREEN Constant Beeping (every 1/2 second) Low Battery Warning - The Back-UPS is supplying battery power to the load connected to the battery outlets, and the battery has 1.5 minutes of battery power remaining. Alternating GREEN & RED Constant tone Bad Battery Detected - Battery needs to be charged, or is at end of life and must be replaced (see Replace Battery). FlashingRED Constant tone Battery Disconnected - The battery is disconnected or it is a bad battery (see Replace Battery). Off Short beep every 4 seconds Low Battery Shutdown - During On Battery operation the battery power was almost completely exhausted, and the Back-UPS is wai...

Herunterladen

Geben Sie zwei Ziffern: