Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Anleitung Zusammenfassung
. The manufacturer recommends that an air director be previously installed in order to distribute the air flow better. The director is fitted as shown in the following figures. • Select the heating function, Fig. 27. • Set the thermostat to the desired temperature. When this temperature is reached, the appliance turns itself off automatically. It comes back on again when the temperature drops 2-3.C. Warning! Do not cover the air intakes or outlets on your appliance! Fig. 24 Fig. 25 Fig. 26 Fig. 27 Cleaning and Maintenance 44 A purifying filter is also fitted inside the basic filter on some models. This purifying filter needs to be changed every year in order to remain operational. (These accessories are available for purchase from the Manufacturer's Official Technical Service and authorised distributors). See "Description of accessories". Installing the purifying filter: • Remove the basic filter from the appliance, Fig. 30. • Fit the purifying filter inside the basic filter as shown in Fig. 31. Cleaning the appliance • For safety reasons, you should unplug the appliance from the mains electricity supply before cleaning. • The appliance can be cleaned with a cloth or sponge, slightly warm water and a mild detergent. • Never use hot water (more than 40.C), bleach, benzene, petrol, acid, scouring pads, brushes or strong detergents. Prevent water from entering the appliance. • Do not clean the appliance with a hose. Cleaning and changing the purifying filters To change the purifying filter, it is first necessary to open the front flap on the appliance (it is not necessary to remove it). The user should lift the flap slightly holding it on the sides, see Fig. 28. The flap can be opened up to the safety stop without risk of falling. All models are fitted with a basic filter which needs to be cleaned regularly, Fig. 29. The filter is accessed by pressing the tab at the top and removing it from its housing, Fig. 30. The filter is cleaned under a cold tap, dried and replaced. Washable basic filter Purification filter Fig. 28 Fig. 29 Fig. 30 Fig. 31 Cleaning and Maintenance 45 • Install the assembly onto the appliance by lining the lower studs up with the slots on the front casing of the appliance and pressing the top clip in until it clicks into position. The assembly is fitted properly when it clicks into position. • Close the front flap. • In order to maintain cooling power, only fit one set of filters onto the support. Note: The flaps on these models are fitted with safety stops up to which point they can be opened without risk of the front flap falling and causing damage and/or injury. The flap can also be removed in order to clean the appliance or change the filters more easily. When removing the flap or in the event of the flap coming out of position for whatever reason, the user should fit the plastic leg on the flap into the groove on the front of the appliance until it is properly rehoused. After refitting, make sure that the flap stops when its reaches the safety stop and does not fall. Storage requirements When the appliance is out of use for a long period, set the expulsion tube to parking position so that the appliance takes up as litt...
Dieses Handbuch ist für folgende Modelle:Splitgeräte - 3XM181E/01 (2.55 mb)
Splitgeräte - 3XM190E/01 (2.55 mb)
Splitgeräte - 3XM190E/02 (2.55 mb)
Splitgeräte - 3XM190E/03 (2.55 mb)