Stimmen - 3, Durchschnittliche Bewertung: 3.7 ( )

Hersteller: Electrolux Dateigröße: 766.89 kb Dateiname: Unterrichtssprache:

The deflector can be swung up and down and also set to the desired angle using the “ X (AUTO SWING)” button. (If the angle of the deflector is changed, it will not return to the auto-set position after operations start unless the operation mode is switched.) If the “ X (AUTO SWING)” button is pressed once, the horizontal air deflector swings up and down. If the button is pressed again, the deflector stops in its current position. Several seconds (about 12 seconds) may be required before the deflector starts to move. If the deflector is not used at fixed angle, set the horizontal air deflectors within range of mark on the side plate for “Dehumidifying” and “Cooling” operations. Swinging the air deflector is effective to reduce unevenness of the temperature in the room. In “Cooling” operation, do not keep the horizontal air deflector swinging for a long time. Some dew may form on the horizontal air deflector and some dew drops may fall from it. When the “ X (AUTO SWING)” button is pressed while the operation is stopped, the horizontal air deflector moves and stops at the position where the air outlet closes. When the auto swing operation is performed, if the horizontal air deflector is moved manually, the swinging range may drift. However, it will return to the original operation range after a short time. 2 ) Adjustment of the conditioned air to the left and right. Hold the vertical air deflector as shown in the figure and adjust the conditioned air to the left and right. - 14 - HOW TO EXCHANGE THE BATTERIES IN THE REMOTE CONTROLLER Replace the batteries when the {+3 (battery) mark in the indicator of remote controller lights. 7 J Remove the cover as shown in the figure and take out the old batteries. 2) Install the new batteries. The direction of the batteries should match the marks in the case. Press the “ © (TIME)” button three times. A CAUTION 1. Do not use new and old batteries, or different kinds of batteries together. 2. Take out the batteries when you do not use the remote controller for 2 or 3 months. 3. The batteries must be of the LR03 type. Push and puli to the direction of arrow. TEMPORARY SWITCH Use the temporary switch when operation can not be done with the remote controller. 1. By pressing the temporary switch, the operation is done in previously set operation mode. When the operation is done using the temporary switch after the power source is turned off and is turned on again, the operation is done in automatic mode. 2. When the operation is stopped or when the operation is done with the remote controller again, press the temporary switch once again. POWER SWITCH When you do not use the room air conditioner, set the power switch to “OFF”. - 15 - ENGLISH MAINTENANCE A CAUTION Before the cleaning, stop operation and disconnect the power supply. Air filter m Clean the air filter, as it removes dust inside the room. It should be washed when the M (FILTER) lamp lights. In case the air filter is full of dust, the air flow will decrease and the cooling capacity will be reduced. Further, noise may occur. Be sure to clean the filter following the procedure below. Procedure Remove the filter. • Press the mark “PUSH” on the left and right sides of the suction grille. • Pull the front cover forward (Until the fixed position). • Slightly lift the filter and release the claws (2 locations) at the lower part of the front cover and remove the filter from the lower side. Remove dust from the filter using a vacuum-cleaner. If there is too much dust, use neutral detergent. After using neutral detergent, wash with clean water and dry in the shade. Install the filters. (Set them with “FRONT” mark facing front.) Slightly lift the suction grille and close as original state. (Press the mark “PUSH” at the left and right sides of the suction grille to fix it securely.) A CAUTION • Do not wash with hot water at more than 40°C. The filter may shrink. • When washing it, shake off moisture completely and dry it in the shade; do not expose it directly to the sun. The filter may shrink. • Do not operate the air conditioner with the filter removed. Dust may enter the air conditioner and cause trouble. - 16 - CLEANING OF FRONT COVER, ETC. 1. The front cover easily becomes dirty. Wipe it with a soft dry cloth. 2. When it is excessively dirty, wipe with a soft cloth soaked in lukewarm water or neutral detergent. Then wipe thoroughly with a soft dry cloth. 3. Never use hot water (above 50°C), benzine, gasoline, acid, thinner or a brush, because they will damage the plastic surface and the coating. MAINTENANCE AT BEGINNING OF LONG OFF PERIOD 1. Running the unit setting the operation mode to 4- (FAN) and the fan speed to HI for about half a day on a fine day, and dry the whole of the unit. WHEN ASKING FOR SERVICE, CHECK THE FOLLOWING POINTS. WHEN IT DOES NOT OPERATE 1. Is the fuse all right? 2. Is the voltage extremely high or low? 3. Is the power switch “ON”? WHEN IT D...

Herunterladen

Geben Sie zwei Ziffern: