Stimmen - 3, Durchschnittliche Bewertung: 4 ( )

Hersteller: Danby Dateigröße: 947.49 kb Dateiname: Unterrichtssprache:

To CANCEL: Press the SLEEP button once more. The mode is set back to the previous operating mode. SLEEP MODE • Decreases the fan speed of Indoor Unit(s) automatically and quiet operation is carried out. • When Sleep mode starts to operate, desired temperature will change automatically (see below). Heat* 3°C(6°F) down an hour after 4°C(8°F) down another 3-hours after Cool & Dry 1°C(2°F) goes up an hour after • When sleep mode starts to operate, flaps will move up or down by one-step automatically. Cool/Dry Move up by one-step Heat* Move down by one-step 1HR TIMER MODE • This mode is convenient to use before sleeping or leaving. tion. Then press the ON/OFF button again, the unit will be set to the previous operating mode. • Upon input, one-hour timer is set at display and 0:30 is indicated current time. • If 1hr timer is set, the remaining minutes will be indicated. NOTE: • If pressing the 1HR TIMER button again during the ONE HOUR TIMER mode, the unit will stop operation approximately one (1) hour later. • The ONE HOUR TIMER mode has preference over other Timer modes. If pressing the 1HR TIMER button again during the OFF TIMER mode, the unit(s) will stop operating approximately one (1) hour later. EMERGENCY OPERATION When the remote control cannot be used due to dead batteries or out of order, use the Hand Switch Lever. After turning the Hand Switch Lever to OFF “O” position, turn it to ON “I” again. The lamp will light and the unit(s) will start in the Automatic operation mode. 9/12 Btuh 18/24 Btuh To STOP: Turn the Hand Switch Lever to OFF ”O” position. ECR International Hyundai Ductless Split System8 MAINTENANCE ROUTINE MAINTENANCE How to replace air filters: MAINTENANCE ROUTINE MAINTENANCE How to replace air filters: Be sure to stop the operation and disconnect the power A) Place the air filters with “Front” marking facing toward yousource before performing any checks or cleaning. in the reverse order of mentioned “How to remove air • Do not wet the air conditioner(s). filters”. • Benzene, thinner and cleaning powder may damage the B) Gently push to close the front grille to the unit. coated surface or the plastics. C) Secure the grille in position by pressing evenly along the • Do not use water higher than 40° C (104° F), or the air lower edge. filters may shrink and the plastic materials may be damaged. 2. CLEANING INDOOR UNIT(S) & REMOTE CONTROL(S) • Do not touch the evaporator coil when removing and replacing the air filters. Injury may occur. Use a dry cloth for cleaning the indoor unit(s) and remote • Never operate the unit without the air filters. control(s). BEFORE THE SEASON 1. CLEANING AIR FILTERS (ONCE EVERY TWO WEEKS) Clean the air filters at least once every two weeks to save elec-• Check that the air inlet and outlet of the indoor and outdoor tricity. Use the vacuum cleaner to remove dust from the air filter. units are not blocked. • Check that the ground wire is connected and there is no NOTE: In case the dust on the air filter ...

Herunterladen

Geben Sie zwei Ziffern: