|
Anleitung Zusammenfassung
No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission of this company. Disclaimer This company makes no representations or warranties, either expressed or implied, with respect to the contents hereof and specifically disclaims any warranties, merchantability or fitness for any particular purpose. Any software described in this manual is sold or licensed "as is". Should the programs prove defective following their purchase, the buyer (and not this company, its distributor, or its dealer) assumes the entire cost of all necessary servicing, repair, and any incidental or consequential damages resulting from any defect in the software. Further, this company reserves the right to revise this publication and to make changes from time to time in the contents hereof without obligation to notify any person of such revision or changes. All brands or product names mentioned in this manual are trademarks or registered trademarks of their respective companies. -2 FCC Statement FCC Class B Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1. Reorient or relocate the receiving antenna. 2. Increase the separation between the equipment and receiver. 3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 4. Consult the dealer or an experienced radio/television technician for help. Notice 1: The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Notice 2: Shielded interface cables must be used in order to comply with the emission limits. -3 Contents 1. INTRODUCTION 1.1 FEATURES .........................................................................................................................................................5 1.2 COMPONENTS AND CONNECTING.................................................................................................................7 1.2.1 Components .................................................................................................................................................7 1.2.2 Connecting Peripherals ................................................................................................................................8 1.2.2.1 Audio Card Output Devices........................................................................................................................9 1.2.2.2 Audio Card S/PDIF Out Devices...............................................................................................................10 1.2.2.3 Audio Card Input Devices......................................................................................................................... 11 1.2.2.4 Audio Card MIDI/Joystick Devices............................................................................................................12 1.2.2.5 System Requirements...............................................................................................................................12 2. INSTALLATION 2.1 HARDWARE INSTALLATION..........................................................................................................................13 2.2 SOFTWARE INSTALLATION ..........................................................................................................................13 2.2.1 SETTING UP IN WINDOWS 95/98/ME ......................................................................................................14 2.2.2 SETTING UP IN WINDOWS NT40.............................................................................................................19 2.2.2.1 Install MPU-401/Joystick Driver...........................................................................................................21 2.2.3 SETTING UP IN WINDOWS 2000..............................................................................................................22 3. APPLICATIONS AOpen Drivers Live Update Wizard.................
Dieses Handbuch ist für folgende Modelle:Computer-Zubehör - AW540 Series (755.09 kb)