Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Anleitung Zusammenfassung
OK REFILL WATER TANK 16 OK FILL CARAFE WITH FRESH WATE 17 CARAFE CLEANING 15 At the end of the wash, fill the tank with Remove the carafe, rinse and refill it with fresh drinking water. Press the "OK" fresh drinking water. button to confirm. Press the "OK" button to confirm. Press the "OK" button to confirm. OK POUR DETERGEN INTO CARAFE & FIL WITH WATER 14 18 Place a large empty container under the dispensing spout. Rotate the upper part of the milk carafe directly above the container. Upon completion of the cleaning cycle, we recommend rinsing all the components under fresh drinking water. The rinse cycle is activated. The bar shows the cycle progress. At the end of the cycle, the machine returns to the product brew menu page. CARAFE RINSING 19 3838 CLEANING MAINTENANCE DURING OPERATION During normal operation, the following messages may appear: "EMPTY COFFEE GROUNDS DRAWER" and/or "EMPTY DRIP TRAY". This operation must be performed when the machine is on. 1 Press the button and open the service door. 2 Remove the drip tray and used grounds drawer. 3 Empty the used grounds drawer and wash it with fresh water. 4 Empty and wash the drip tray and the cover with fresh water. 5 6 Correctly reinstall all the components. Insert the tray and the coffee grounds drawer and close the service door. If the used grounds drawer is emptied when the machine is off, the coffee grounds counter is not reset. For this reason the machine might display the "EMPTY COFFEE GROUNDS DRAWER" message after brewing just a few coffees. GENERAL MACHINE CLEANING 39 The cleaning procedure described below must be carried out at least once a week. Note: If water remains in the tank for several days, do not use it. WARNING! Never immerse the machine in water. 1 Turn off the machine and unplug it. 2 Take out the water tank and wash it with fresh water. 3 Take out the water recovery tray. 4 5 6 Wash the water recovery tray. After drying it, reassemble and reinsert it in the machine. Remove the grill and wash it thoroughly. Remove the support under the grill. Wash it taking care of the seal area. Reinstall the support only after washing the inside of the water recovery tray. 7 Remove the dispensing spout and wash it with water. 8 Clean the pre-ground coffee compartment with the provided cleaning brush. 9 Clean the steam wand and the display with a dry cloth. 4040 CLEANING BREW GROUP CLEANING Wash the brew group at least once a week. Before removing the group, remove the used grounds drawer as shown in fig. 2 on page 38. Wash the brew group with lukewarm water. Lubricate the brew group after approximately 500 brewing cycles. The brew group lubricant may be purchased from an authorized service center. WARNING! Do not wash the brew group with detergents that may compromise its correct operation. Do not wash it in the dishwasher. 1 Press the PUSH button to remove the brew group. 2 Wash the brew group and the filter and dry. 3 Lubricate the brew group guides using the supplied lubricant. 4 Apply the lubricant evenly on both side guides. 5 Make sure the brew group is in rest position; the two references must match. 6 Make sure the components are in the correct position. The hook shown must be in the correct position; to check its position, firmly press the “PUSH” button. 7 The lever on the rear part of the group must be in contact with the group base. 8 Insert the washed and dried brew group. DO NOT PRESS THE “PUSH” BUTTON. 9 Insert the used grounds drawer and close the service door. MILK CARAFE CLEANING 41 The carafe must be removed and properly washed at least once a week. This procedure guarantees the perfect sanitation of all components. Note: Pay attention to how the components are assembled. This little shrewdness will facilitate the subsequent reassembling. The inner side of the service door shows a quick guide on how to reassemble the carafe. 1 32 The carafe must be removed from the Disengage the handle by rotating it Press on the sides and lift the lid. machine and emptied for its cleaning. clockwise. 4 65 Rotate the handle counter-clockwise to Remove the connector which is in Remove the handle with the suction the unlock position. contact with the machine. hose. 7 98 Remove the suction hose. Remove the external fitting by pulling it. Remove the internal fitting. All components can be thoroughly washed with hot water. After washing the components, reassemble them by following the instructions on next page. 4242 CLEANING MILK CARAFE ASSEMBLY Pay attention during the assembly phase. In case the components do not smoothly enter in their positions, read the instructions more carefully and repeat the assembly procedure. Note: The inner side of the service door shows a quick guide on how to reassemble the carafe. 1 32 Insert the inner fitting in the hose and press until fully inserting it. 4 Insert the unit previously assembled in the cover base. Pay attention to the reference. Insert the outer fitting in the inner Insert the hose in the outer fitti...