Stimmen - 4, Durchschnittliche Bewertung: 3.3 ( )

Hersteller: AEG Dateigröße: 737.53 kb Dateiname: Unterrichtssprache:

2/0) because it is pre-set in the factory. By pressing the “ip” button for the warming level (Fig 2/N), however, you can pre-select a lower warming temperature independently of this, at Level 1, or a high temperature at Level 3. The warming level selected will appear in the display (Fig. 2/0). When the appliance is next switched on again, the figure for the warming level will automatically appear which was selected last time. Initial brewing phase (only KF 1064 and KF 1066 Black Line) Your coffe-makers has a function called an initial brewing phase to ensure the maximum coffee aroma. After the first small quantity of water has dampened the ground coffee in the filter, the coffee-making cycle is then interrupted for a short time. During this time, the ground coffee soaks up the water, thus enabling it to develop its full aroma. The result is the maximum coffee aroma. 7. Taking the jug out When the jug is taken out, the filter valve prevents drips from dropping onto the warming plate. The warming plate always keeps the coffee hot enough to drink. Automatic switch-off after end of cycle: As a safety device for your protection, the appliance automatically switches itself off about two hours after it has finished brewing, even if you have programmed the timer (see below). Please remember: to make sure the coffee is of uniform strength, you should stir it before pouring it out. When the cycle has finished and you wish to fill more water into the tank for the next batch of coffee, please switch the appliance off and wait a few minutes for it to cool down. Coffee’s-ready! signal (only on KF 1064 and KF 1066 Black Line) Pressing the “signal” button (Fig. 2/L) will activate the Coffee’s-ready! signal, and the lettering “signal” will appear in the display (Fig. 2/M). At the end of the brewing cycle you will hear an audible signal to tell you: Coffee’s ready! Once it has been activated, the Coffee’s-ready! signal will sound both in timer operation (see next section) and in normal operation. Press the “signal” button once again to turn the Coffee’s-ready! signal off, and the lettering “signal” will disappear from the display. Programming the timer Your AEG coffee-maker possesses a timer with which the time of day can be set and the coffee-maker programmed to switch itself on up to 24 hours later. 1. Setting the time of day Setthe correct hours and minutes by means of the buttons “h” (Fig. 2/H) and “min” (Fig. 2/J), which you press once each to advance the time by one hour or one minute. If you hold these buttons down, the figures will run continue to run automatically in the display until you let go of the button again. The buttons are secured against being accidentally re-set. To adjust the time of day, you have to hold the buttons down for about two seconds before the time can be altered. 2. Programming the switch-on time. First press the “progr” button (Fig. 2/K). By pressing the “h” button (Fig. 2/H) or “min” (Fig. 2/J) immediately af...

Herunterladen

Geben Sie zwei Ziffern: