Login:
Stimmen - 5, Durchschnittliche Bewertung: 4.2 ( )

Anleitung Grindmaster, modell AT-AP/AT-APE

Hersteller: Grindmaster
Dateigröße: 703.89 kb
Dateiname:
Unterrichtssprache:en
Link zum kostenlosen Download Hinweise finden Sie am Ende der Seite



Anleitung Zusammenfassung


6) In higher altitude locations (5,000 feet/1,500m above sea level) the thermostat may have to be adjusted lower to prevent boiling. Page 4 Auto Series Brewer Manual COFFEE PREPARATION PROCEDURES (Pour-Over Mode) 1) Place filter into brew basket. 2) Put the proper amount of coffee into the filter. 3) Slide the brew basket into holder. 4) Place empty decanter on warmer located directly under the brew basket and turn corresponding warmer switch ON. NOTE: For airpots, open airpot lid, remove pump stem from airpot and place airpot opening directly under center hole in brew basket. 5) Pour decanter of fresh water through pour-in opening at top of brewer. 6) Hot water will be delivered through the sprayhead. This distributes the hot water evenly over the coffee bed within the brew basket. The coffee will drain from brew basket into the container below. 7) TURN OFF WARMER WHEN NOT IN USE. (Red light indicates warmer is ON.) Not for airpot brewers. 8) Before brewing next pot, remove brew basket from brew rails and dump filter into waste basket. COFFEE PREPARATION PROCEDURES (Auto Mode) 1) Place filter into brew basket. 2) Put the proper amount of coffee into the filter. 3) Slide the brew basket into holder. 4) Place empty decanter on warmer located directly under the brew basket and turn corresponding warmer switch ON. NOTE: For airpots, open airpot lid, remove pump stem from airpot and place airpot opening directly under center hole in brew basket. 5) Press Brew switch once then release. 6) Valve will turn on approximately 1 minute and fill pour-in basin. 7) Hot water will be delivered through the sprayhead. This distributes the hot water evenly over the coffee bed within the brew basket. The coffee will drain from brew basket into the container below. 8) TURN OFF WARMER WHEN NOT IN USE. (Red light indicates warmer is ON.) Not for airpot brewers. 9) Before brewing next pot, remove brew basket from brew rails and dump filter into waste basket. 10) Do not press Brew switch more than once during brew cycle. BREW VOLUME ADJUSTMENT 1) Disconnect power to brewer. 2) Remove plug on upper left side of chassis. 3) With a flat head screwdriver, turn dial clockwise slightly to increase volume and counter-clockwise to decrease volume. 4) Reconnect power and run a brew cycle to check volume. 5) Repeat steps 1-3 if necessary. BREW BASKET RAIL ADJUSTMENT 1) Disconnect power to brewer. 2) Remove lid and pour-in basin. 3) Loosen nuts for brew rails. 4) Fit basket in place. 5) Tighten nuts and check basket fit. Auto Series Brewer Manual Page 5 SPARE PARTS LIST Item No. Part No. Description Item No. Part No. Description 1 73035 Water Tank 33A 73187-1 Decal, Main Front AT-AP, AT-TC 2A 73252 Clamp Hose, Nylon 1/2" ID 33B 73187 Decal, Main Front W/Switch Power AT-AP, AT-TC 2B 07327 Clamp, Black 5/8" 34 06491 Deflector, Spray HD 3 71155 Tubing, 5/16"ID x 1/2"OD Silicone 35 06490 Nozzle, Spray HD 4 73173 Heat Exchanger Inside Tank 36 07220 Nut, Lock Palnut Spray HD 5 70818 Element, Heating 1400W 120V 37 70341 Elbow, Silicone 90 deg 70820 Element, Heating 2500W 240V 38 73242 Hole Plug 73222 Element, Heating 1780W 120V 39 71093 Pipe Adapter 6 73037-1 Inlet Tube Assembly 40 73179 Timer Relay, 120V 7 73186A Cover, Tank W/Bracket, Thermostat 73251 Timer Relay, 230V 8 61143 Nut, Pipe Jam 1/8" NPT 41 73114 Bracket, Panel Spray HD 9A 73176 Fitting Brass 1/4"MFL x 3/8"MPT 42 73003 Top Cover SS, AT-AP, AT-3WR 9B 73177 Fitting Brass 1/4"MFL x 3/8"NPT 43 71607 Panel, Pour-Over Lid 10 05826 Tubing, 3/8"ID x 5/8"OD Silicone 44 71529 Wire Hinge, Pour-Over Lid 11 73033 Elbow Brass, 1/8" NPT 3/8" Barb 45 73008 Nut Slotted Hex SS (size M20x1.5) 12 71147 Grommet, White Silicone 46 73010 Pan, Receiving 13 61243 Grommet, Dump Valve 47 73175 Assy, Water Line to Faucet 14 73178 Fitting, 1/4"MFL x 3/8" Barb 48 73188A Top Body Assemply AT-AP, AT-TC 15 73234 Tube, Inner Braided Silicone 49 73191 Panel, Back AT-AP, AT-APE 16 60550 Clamp Hose, Stainless 50 73232 Valve Inlet 120V, 50/60Hz 17 73036 Thermostat Regulating 73233 Valve Inlet 230V, 50/60Hz 18 62237 T-Stat, Hi-Limit, 120V Models 51 73021 Bracket, Tank Base AT-AP, AT-APE 100523 T-Stat, 1/2" Manual Reset 230V Models 52 73192 Panel Center SS. AT-AP, AT-APE 19 62238 Bracket, Hi-Limit 120V Models 53 73190 Panel, Back AT-TC, AT-2W, AT-3WR 1...

Dieses Handbuch ist für folgende Modelle:
Kaffeemühlen - AT-2W/AT-2WE (703.89 kb)
Kaffeemühlen - AT-TC/AT-TCE (703.89 kb)
Kaffeemühlen - AT-3WR/AT-3WRE (703.89 kb)

Bewertungen



Bewerten
Vorname:
Geben Sie zwei Ziffern:
capcha





Kategorien