Stimmen - 3, Durchschnittliche Bewertung: 4.7 ( )

Hersteller: Stovax Dateigröße: 117.77 kb Dateiname: 97103be3-105c-4f27-9729-ed19509d89ed.pdf Unterrichtssprache:

If a cement infill is required to achieve this, do not proceed with the installation until the cement is completely dry. Cover the surface of the hearth to protect it from damage during installation of the cast panel. Protect the surfaces of the surround (mantelpiece) from damage when trial fitting of the panel. Position the front panel centrally in the fireplace opening against the wall. Place the surround (mantelpiece) in position and, holding it firmly against the wall, pull the front panel forward until it touches the rear of the surround. The panel is now in the correct position and should be fixed. The surround can be removed while this is completed. There are a number of ways of fixing the front panel, but a typical method is:- Drill through the 4 corners of the main panel in a position that will be covered when the surround is in position. Drill holes in the wall in corresponding position, and secure the front panel with 75mm (3") screws and non-plastic wall plugs. Fill any gaps between the wall and the panel with a non-combustible material, such as fibreglass rope seal or Stovax fire cement, to form airtight seal. Never use strong Portland cement mortar in chimneys and fireplaces. A lime based mortar will allow expansion and movement and reduce the risk of cracking. Wait until any cement or seals are dry before fitting a wooden surround. If the surround is wood, fix Stovax flat rope seal (Part No. 4953) to all surfaces that touch the cast iron panel. Place it into position ensuring that it is central, and secure it to the wall using flat brass brackets (mirror plates). With Solid fuel fires use only at a low fire for the first few hours of use to allow the castings to temper. During this time the fireplace may give off some unpleasant odours, and we recommend that you keep the room well ventilated to avoid a build-up of fumes. Safety As with all fireplaces the surfaces will become very hot when in use, therefore due care should be taken when near the fireplace. If it is to be used in the presence of young children, elderly or infirm persons a suitable fireguard should be used. Care should also be taken with the placement of combustible items near the fireplace as conducted and radiated heat could cause a fire hazard. Stovax offer a wide range of firescreens and sparkguards, along with a hearthgate system designed to offer full protection for a range of stoves and fireplaces. Your Stovax dealer can advise you on these products. If a chimney fire occurs evacuate all persons from the building before calling the fire brigade. Do not re-enter the building until it is confirmed safe to do so. Following a chimney fire do not use the fireplace until it is inspected, by a HETAS (CB only) registered installer, to confirm that the appliance is safe to use, or make any repairs required before re-use. Only genuine Stovax replacement parts are to be used to keep your fireplace in safe and efficient working order. After any chimney fire i...

Herunterladen

Geben Sie zwei Ziffern: