Stimmen - 4, Durchschnittliche Bewertung: 4 ( )

Hersteller: FireplaceXtrordinair Dateigröße: 4.64 mb Dateiname: Unterrichtssprache:

Use the four (4) framing brackets provided on the firebox to attach firebox to framing. Different hole locations can be used for finishing materials with thicknesses of 3/8", 1/2" and 3/4". Attach these materials with screws provided, two (2) per framing bracket. See Figure 8. Framing brackets should fit directly against framing material. Use at least one (1) nail per bracket to secure in place. Check squareness of the firebox prior to securing to framed opening. See Figure 9. Figure 8 A black hood that is furnished with each firebox (or optional hood) MUST be installed before the firebox is used. Failure to do so may create a possible fire hazard. The hood is located behind upper louver, or inside the firebox on flush face units. If brass, stainless steel, or hammered pewter hoods are desired, they can be purchased as an option. Attachment is the same as the standard black hood. Flush Face Models 1. On flush face models, loosen the two screws (A) holding firebox top to face panel, then slide the hood flange between the firebox top and face panel and re-tighten the screws. 2. Install one (1) screw at each end of the hood as shown (C). Louvered Models 1. If you have a louvered model, remove upper louver. 2. Place the top hood flange on top of the firebox, then install three screws through the firebox top from below and screw into the pilot holes in the hood flange (B). 3. Install one (1) screw at each end of the hood as shown (C). 4. Re-install louver. Caution: The hood must be installed prior to operation of appliance. See Figure 10 ATTACH (4) FRAMING BRACKETS TO SIDES OF FIREBOX PRIOR TO INSTALLING UNIT TO FRAMED OPENING A C A C C B B C B Louvered Models Flush Face Models Figure 10 FIREBOX OPENING CHECK TO SEE THAT BOX IS SQUARE PRIOR TO ATTACHING TO FRAMING Figure 9 FIREBOX INSTALLATION INSTRUCTIONS (continued) INSTALLING HOOD Page 8 23200-0-1206 The firebox is designed to accept a 3/8-inch gas line for an approved vent-free gas logset. Have the line installed by a qualified service person in accordance with all building codes. Consult local building codes to properly size the gas supply line leading to the 3/8-inch hook-up at the unit. The state of Massachusetts requires that a flexible appliance connector cannot exceed three feet in length. Gas access holes are provided on both sides of the firebox. See Figure 11. On models with ceramic brick panels installed, carefully remove the indented knockout in the ceramic brick panel using a drill or utility knife. See Figure 12. When installing optional ceramic fiber side panels into firebox, lay panel on a flat surface. Remove the gas line knockout (round depression) in the appropriate side panel using a drill or utility knife. After the brick panel knockout is removed, the firebox wrap may have a round metal knockout that must be removed also. Use a screwdriver to punch out the metal knockout. Check gas type. Use only the gas type indicated on the gas log set rating plate. If the gas listed on the ...

Herunterladen

Geben Sie zwei Ziffern: