Stimmen - 2, Durchschnittliche Bewertung: 3.5
(
)
)
|
Anleitung Zusammenfassung
• DO NOT BURN WASTES, FLAMMABLE FLUIDS SUCH AS GASOLINE, NAPHTHA OR MOTOR OIL. • DO NOT CONNECT TO ANY AIR DISTRIBUTION DUCT OR SYSTEM. • ALWAYS CLOSE THE DOOR AFTER THE IGNITION. TECHNICAL SPECIFICATIONS Combustible: Wood Recommended Surface 500 to 1 500 ft2 (47 to 140 m2) Heating Capacity : E.P.A : 44 000 BTU/h (12.8kW) Efficiency : 75.32 % Emissions: 6.28 g/h Colours : Metallic Black Flue Pipe Diameter : 6’’ (152 mm) Chimney type : 2 100°F (650 °C) Minimum Chimney Height : 12’ (3,66 m) Maximum Log Length : 18’’ (460 mm) Dimensions Overall: Eldorado Celtic : Adirondack, Savannah : Jurassien : W x D x H 25 x 24 x 26’’ (635 x 533 x 660mm) 25 x 24 x 26’’ (635 x 533 x 660mm) 31 x 18 . x 29 .’’ (788 x 476 x 756mm) Combustion Chamber : Width x Depth : Volume : W x D 20 . x 11 . ’’ (514 x 286 mm) 1,47 pi3 (0,04 m3) Door Opening : All Models : W x H 7 5/8’’ x 18 1/4’’ (200 x 464 mm) Pyroceram Glass Door : Adirondack, Celtic, Savannah, Eldorado : Jurassien : W x H 8 . ’’ x 16 . ’’ (222 x 419 mm) 10’’ x 18 . ’’ (254 x 464 mm) Weight: Eldorado : Adirondack, Celtic, Savannah : Jurassien : 255 lbs ( 116 Kg) 280 lbs ( 127 Kg) 415 lbs ( 188 Kg) OPTIONS PART NUMBER Ultra-quiet blower with variable speed control All Models: AC02050 Thermodisc 90 -120oF (32-490C). All Models: AC05530 Outside air intake kit All Models: AC02080 ASSEMBLY PEDESTAL AND PANELS Pedestal Base Installation: 1. Slide the front part of the pedestal base around the pedestal and fix the rear part with the two supplied screws. 2. Slide the ash pan in position. Side Panels and Ash Lip Installation: 1. Start by fixing the front part of the decorative side in the two clips welded on the sides of the fire box. 2. Then, fix the back of the decorative side with two screws and washers supplied. Line up the decorative side parallel to the side of the appliance. 3. Clip the ash lip into position, centred just below the door. LEGS AND ASH PAN Ash Lip Installation : 1. Just clip the ash lip into position, centred just below the door. 2. Slide the ash pan in position. DOOR ADJUSTMENT In order for your stove to operate properly, the door should be adjusted periodically to provide an air tight fit. To adjust: • Remove the lock pin (spring pin) by pulling and turning it using pliers ("wise grip") • Turn the handle counter clock wise one turn to increase pressure • Re-install the lock pin (spring pin) with a small hammer Figure 1: Door Adjustment THE BENEFITS OF INSTALLING A BLOWER A blower can be installed at the back of your DROLET stove. This option is necessary if you wish to redistribute into a room the heat trapped at the back of your stove. By forcing hot air toward the front, the blower enables you to extend the radiation power of your stove. You can purchase this option through your DROLET dealer. Make sure to specify this part number: #AC02050. You can also install a thermodisc to enable the blower to start or stop automatically when the stove is hot or too cold. The thermodisc part number is AC05530. Installation instructions are supplied with the blower and the thermodisc. INSTALLATION SAFETY NOTICE • IF THIS STOVE IS NOT PROPERLY INSTALLED, A HOUSE FIRE MAY RESULT. TO REDUCE THE RISK OF FIRE, FOLLOW THE INSTALLATION INSTRUCTIONS. FAILURE TO FOLLOW INSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE, ...
Dieses Handbuch ist für folgende Modelle:Kamine - Celtic (283.58 kb)
Kamine - ElDorado (283.58 kb)
Kamine - Jurassien (283.58 kb)
Kamine - Savannah (283.58 kb)