Stimmen - 3, Durchschnittliche Bewertung: 3.3
(
)
)
|
Anleitung Zusammenfassung
Please read and understand these instructions before beginning your installation. Do not alter or modify the fireplace or its components under any circumstances. Any modification or alteration of the fi replace system, including but not limited to the fireplace, chimney components and accessories, may void the warranty, listings and approvals of this system and could result in an unsafe and potentially dangerous installation. IMPORTANT! TO ASSURE PROPER ALIGNMENT OF GLASS DOORS: INSTALL THIS FIREPLACE IN A SQUARE AND PLUMB CONDITION, USING SHIMS AS NECESSARY AT SIDES AND/OR BOTTOM. WH Report No. J99025865A TABLE OF CONTENTS Safety Rules ......................................Page 2 Tools and Building Supplies ..............Page 2 Precautions .......................................Page 2 Introduction ......................................Page 3 Clearances/Height Requirements ......Page 3 Chimney System ...............................Page 3 Assembly Outline ..............................Page 4 Location of Fireplace .........................Page 4 Assembly Steps ................................Page 5 Preinstallation Notes .........................Page 5 Clearances ........................................Page 5 Installing the Fireplace ......................Page 5 Fireplace Specifi cations .....................Page 7 Framing Specifi cations ......................Page 7 Installing the Chimney System ..........Page 8 Ten Foot Rule Summary ....................Page 10 Special Offset Instructions ................Page 11 30° Offset through Floor/Ceiling .......Page 11 Chimney Component Calculations ....Page 11 Offset Calculations ............................Page 11 Vertical Elevation Chart ....................Page 12 Offset Elevation Chart ........................Page 13 Installing Offsets ...............................Page 14 Optional Equipment Considerations ..Page 14 Blower ...............................................Page 14 Combustion Air Kits ..........................Page 15 Gas Line Connection .........................Page 15 Cold Climate Insulation .....................Page 15 Glass Doors ......................................Page 16 Fireplace Finishes ..............................Page 16 Mantels and Trim ..............................Page 16 Hearth Extensions/Wall Shields ........Page 16 Finish Requirements .........................Page 18 Installation Components ...................Page 18 PACKAGING The assembled wood fireplace is packaged with: 1 - One envelope containing the literature pack age which consists of the homeowner's manual, installation instructions and war ranty (located in the fi rebox). 2 - One Combustion Air Kit IMPORTANT: PLEASE READ AND UNDERSTAND THESE RULES TO FOLLOW FOR SAFETY. SAFETY RULES: WARNING To avoid the risk of damaging fireplace materials and increasing the risk of fire, do not use the fi replace to cook or warm food. 1. Before starting your fireplace installation, read these installation instructions carefully to be sure you understand them completely and in entirety. Failure to follow them could cause a fireplace malfunction resulting in serious injury and/or property damage. 2. Always check your local building codes. The installation must comply with all local, regional, state and national codes and regulations. 3. These fireplaces must be installed with Security Chimneys FTF8 (8" inside diameter) Chimney System only. These systems are intended for use in any application where a traditional masonry type fireplace would apply. The chimney system must always vent to the outside of the building. 4. To ensure a safe fireplace system and to prevent the build-up of soot and creosote, inspect and clean the fireplace and chimney prior to use and periodically during the heating season. 5. Burn approved fuels only as defined in the Homeowner's Care and Operation Manual. 6. DO NOT use charcoal or coal under any circumstances. 7. NEVER use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter fluid, or similar liquids to start or “freshen up” a fire in this fireplace. Keep any flammable liquids a safe distance from the fi replace. 8. NEVER leave children unattended when there is a fi re burning in the fi replace. 9. Always keep flue damper open when heat is present in the fi replace. 10.Before servicing, allow the fireplace to cool. Always shut off any electricity or gas to the fireplace while working on it. This will prevent any possible electrical shock or burns. 11.This fireplace is not intended to heat an entire home or be used as a primary heat source. It is designed to provide aesthetics and limited heat to the room. 12.Always ensure an that adequate supply of replacement combustion air from the outside of the house is accessible to the fire to support normal combustion. Fireplaces consume large volumes of air during the normal combustion process. • In the event the home is tightly sealed with modern energy efficient features, the combustion air kit (provided) may...
Dieses Handbuch ist für folgende Modelle:Kamine - BCD36MH (1.11 mb)