Stimmen - , Durchschnittliche Bewertung: ( )

Anleitung Monessen Hearth, modell BV4000C

Hersteller: Monessen Hearth
Dateigröße: 948.94 kb
Dateiname: BV4000C.pdf

Unterrichtssprache:

Das Dokument wird geladen, bitte warten

HerunterladenSchließen

Das Dokument wird geladen, bitte warten

HerunterladenSchließen

P/N 775006M, Rev. J, 04/01 IMPORTANT WARNINGS CAUTION: Read this manual thoroughly before starting installation. For your safety, follow the installation, operation and maintenance instructions exactly without deviation. Failure to follow these instructions may result in a possible fire hazard and will void the warranty. If this appliance is not properly installed, a house fire may result. Contact local building or fire officials about restrictions and installation inspection in your area. 1. If utilizing an older chimney, it must be inspected for adequate serviceability. Refer to the heading Chimney Inspection on page 6. 2. Install only in masonry fireplaces, built to UBC chapter 37 standards or listed factory built fireplaces. 3. The minimum clearances must be maintained for all combustible surfaces and materials including; furniture, carpet, drapes, clothing, wood, papers, etc. Do not store firewood within this clearance space. 4. This appliance requires a non-combustible heat resistant approved fireplace hearth or hearth extension. This protected area must extend a minimum of 16" to the front of the fuel door opening and 8" beyond both sides of the fuel door opening (see floor protection on page 5 for additional information). 5. Minimum ceiling height must be 7 feet (measured from base of appliance to ceiling). 6. DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE CONNECTED TO ANOTHER APPLIANCE. 7. Do not connect this appliance to air ducts or any air distribution system. 8. Do not install appliance in a sleeping room. 9. PREVENT CREOSOTE FIRE: Inspect and clean chimney frequently. Under certain conditions of use, creosote buildup may occur rapidly. Inspect chimney connector and chimney twice monthly and clean if necessary. Using green or inadequately seasoned wood can greatly increase creosote buildup. Use dry wood to minimize creosote buildup. 10. USE SOLID WOOD FUEL ONLY: This appliance is approved for burning dry seasoned natural wood only. 11. Never use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter fluid, or similar liquids to start or "freshen up" a fire in this heater. Keep all such liquids well away from the heater while it is in use. 12. DO NOT OVERFIRE: If heater or chimney connector glows, you are overfiring. Overfiring this appliance could cause a house fire. Overfiring is a condition where the appliance is operated at temperatures above its design capabilities. Overfiring can be caused by improper installation, improper operation, lack of maintenance or improper fuel usage. Damage caused from overfiring is NOT covered under the manufacturers limited warranty. 13. NEVER LEAVE AN UNATTENDED FIREPLACE INSERT BURNING ON HIGH. Operation of the fireplace insert with the primary air control at its highest burn rate setting for extended periods can cause dangerous overfiring conditions. The primary air control should only be positioned at the highest setting during start-up procedures and for short durations. When leaving the fireplace insert unattended ensure that the primary air control is set to the low or medium low range. 14. Use a metal container with a tight fitting lid to dispose of ashes. 15. Burning any kind of fuel uses oxygen from the dwelling. Be sure that you allow an adequate source of fresh air into the room where the fireplace insert is operating (see Ventilation on page 6). 16. CAUTION: HOT WHILE IN OPERATION. An appliance hot enough to warm your home can severely burn anyone touching it. Keep children, clothing and furniture away. Contact may cause skin burns. Do not let children touch the appliance. Train them to stay a safe distance from the unit. 17. Once the fire is established, never burn the appliance with the bypass open, except when refueling the appliance. 18. CATALYTIC COMBUSTOR: Do not operate this appliance without the catalytic combustor assembly (this consists of ceramics, gasket and a housing) properly installed. Burning of metal foils, coal, plastic garbage, diesel oil and sulfur will make the catalyst in the combustor inactive. The combustor is fragile; handle carefully. The performance of the catalytic device or its durability has not been evaluated as part of the certification. 19. Build fires directly upon the brick hearth inside the fireplace insert. Do not use grates, irons or any other method to elevate the fire. 20. SAVE THESE INSTRUCTIONS. 21. See the listing label located on the back of fireplace (or see Safety/Listing Label on page 26). PAGE 2 TABLE OF CONTENTS Important Warnings ................................................. 2 Testing / Listing, EPA, Using this Manual ............... 3 Planning Your Installation......................................4-7 Installation .......................................................... 8-11 Product Features and Controls ............................. 11 Care and Operation .......................................... 13-16 Recommended Fuel............................................... 17 Maintenance........