Stimmen - 3, Durchschnittliche Bewertung: 4.7 ( )

Hersteller: Casio Dateigröße: 405.91 kb Dateiname: 994630000_Rev_E_NO_PHONE.pdf Unterrichtssprache:

CAUTION! ^ Disconnect the power cord. Failure to do so can result in damage to the unit or personal injury. U sing the enclosed magnetic screwdriver, remove the two (2) indicated screws, loosening the chassis panel cover. Rotate the unit so the panel with the vents is facing you. Remove the panel and set it aside. Step 2. Locate the power cable [1] and serial ATA cable [2]. Proceed and disconnect these cables from the hard drive. IMPORTANT! Some force may be required to initiate removal of the cables. Grasp the cable connectors where possible and take caution not to damage the cables. Pull with equal force on both sides of the cable connectors to remove them. Step 3. Using the enclosed magnetic screwdriver, remove the two (2) indicated screws from the hard drive bracket. Step 4. Pull the hard drive bracket enclosure from the unit in the direction of the arrow. Step 5. Using the enclosed magnetic screwdriver, remove the two (2) indicated screws and set aside. P/N 994630000 Rev. E 1/2 VGC-RBxx Series Hard Disk Drive Replacement Instructions Step 6. Remove the indicated screws from the opposite side of the bracket and set aside. Notice position of the bracket and HDD Step 7. Pull out the original hard drive from the bracket in the direction of the arrow. IMPORTANT! Take note of the original position of the drive inside the bracket. Notice position of the pins Step 8. Gently insert the new hard drive into the bracket in the direction of the arrow. Align the new drive in the same position as the original hard drive. ■ » -©I Step 9. Reinstall the four (4) previously removed screws into indicated positions on both sides of the bracket. IMPORTANT! Do not over tighten the screws! Step 10. Slide the hard drive bracket enclosures back inside the unit, making sure all holes are lined up. Step 11. Using the enclosed magnetic screwdriver, reinstall the two (2) previously removed screws. IMPORTANT! Do not over tighten the screws. Step 12. Gently reconnect the previously removed power connector marked P8 [1] into the hard drive as indicated above. Step 13. Gently reconnect the serial ATA cable [ ] into the hard drive as indicated above. Step 14. Re-assemble the chassis panel cover. And reinstall the screws removed in step 1. Connect your PC and continue with the recovery following the instructions on the back of the recovery disk's case. Return the original hard drive to Sony following the included shipping instructions. P/N 994630000 Rev. E 2/2...

Herunterladen

Geben Sie zwei Ziffern: