REVISED APRIL, 2009 (BL) WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC. (FOR MODELS MANUFACTURED SINCE 10/04) CA6450# PRINTED IN TAIWAN A WARNING! This manual provides critical safety instructions on the proper setup, operation, maintenance and service ofthis machine/equipment. Failure to read, understand and follow the instructions given in this manual may result in serious personal injury, including amputat

Push the reverse valve, shown in Figure 1, in or out to change direction. Turn the valve knob from 1 to 6 to adjust air flow. Connect to air line regulated at 90 PSI. Reverse Valve Grease Fitting Figure 1. Model H8220 Insert one shot of grease into the grease fitting shown in Figure 1, every three months. The impact wrench MUST be regularly lubricated with 3-4 drops of air tool oil directly into the air fitting before each use. For best results, we recommend using an in line filter, lubricat

Installing the resaw fence on your old fence requires that you drill a hole in your old fence. Inventory (Figure 1) A. Resaw Fence.............................................1 B. Adjustment Handle.....................................1 C. Flat Washer 8mm.......................................1 D. Moving Plate...............................................1 Drilling the Hole Before starting, you should have a pencil, a measuring tape, a center punch, a hammer, a 3/8" drill bit, and access

Diagram for drilling the hole. Figure 3. Installing resaw fence. 3. Mount the fence assembly on the bandsaw. H7528 Parts Breakdown and List REF PART # DESCRIPTION 1 PH7528001 FENCE (AL) 505MM 1 2 PH7528002 MOVING PLATE 1 3 PW01M FLAT WASHER 8MM 1 4 PH7528004 LOCK KNOB M8-1.25 X 44 1 5 PH7528005 END COVER 148 X 22 X 1 2 6 PHTEK3M TAP SCREW M3.5 X 8 4 COPYRIGHT © JUNE, 2005 BY GRIZZLY INDUSTRIAL, INC. REVISED NOVEMBER, 2006. WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SH

The rated load is for an evenly distributed, vertically applied load. Overloading may result in personal injury or property damage. • This jack should only be used to help stabilize an already lifted vehicle or support hanging auxiliary components, such as a driveline or transmission. It is not designed to support the weight of an entire vehicle. • ONLY use this jack stand on a hard level surface capable of sustaining the load being supported. • Always make sure that the load point is centere