Stimmen - 2, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
15/16 Bridle Close - Stewarts Road Finedon Industrial Estate manifactured by DE’LONGHI Via L.Seitz, 47 Wellingborough TREVISO 31100 ITALY Tel. 01933442040 HEATER SAFETY INSTRUCTIONS. (KEEP IN A SAFE PLACE). SPARE COPIES OF THIS LEALET CAN BE OBTAINED FROM YOUR DEALER INSTRUCTION 1 ALWAYS use Heater in accordance with instructions supplied with each Heater. Keep instructions in a safe place. 2 DO NOT position Heater close to chairs and fabrics 3 DO NOT move Heater from room to room when it is lit. 6 A LEAK WILL SMELL DO NOT position Heater alongside a wall or IF a leak is suspected, turn the gas off at the near curtains, etc. ALWAYS face Heater cylinder. DO NOT disconnect the regulator. Extinguish all naked lights. Check all connections. towards centre of room. Slowly turn the gas on and brush the connectors Special care should be taken if the Heater is with soapy water or liquid detergent - a gas leak on a surface where it can move or twist on its will form bubbles. If a leak is found turn the gas off wheels or castors if knocked by a child or and inform your Dealer. DO NOT use the heater dog, etc. again until it has been inspected by your Dealer. If the cylinder valve appears to be leaking when turned off, refit the Black Branch Cap or Orange valve Cap. -This appliance MUST NOT be used in a basement, high rise flats, bathrooms or bedrooms and in rooms having volume less than 15 m3 (30m3 in living rooms) for three burner models; 18m3 (36m3 in living rooms) for two burner models. -Be sure installation is complying to local standard. -Do not install the appliance in a room which might contain gas, oil or sulphur, or near sources of heat. -The heater you have purchased is fitted with safety devices which come on in the event of malfunctioning while the appliance is in use. If the pilot (placed opposite the burner) accidentally goes out, or if the room is not sufficiently ventilated, the safety device will block the gas flow, causing the heater to go off. VENTILATION USE ONLY IN WELL VENTILATED ROOM. DO NOT CHANGE CYLINDERS IN THE PRESENCE OF NAKED LIGHTS. NEVER USE A MATCH OR NAKED FLAME TO SEARCH FOR LEAKS. 4 DO NOT place clothes or other materials on the Heater, as apart from the danger of fire their presence could affect the efficient working of the appliance. 5 ASSEMBLY 1) Place the gas cylinder in the gas cylinder compartment and connect the regulator to the cylinder as shown on page 3. 2) To fit the backcover, insert the two tabs located on the left-hand side of the backcover into the corresponding slots in the cabinet. Then insert the tab on the right hand side into its slot. IMPORTANT: to remove the backcover, lift the backcover and pull clear of the slots. Gas cylinder compartment Slot Tabs 2 MODEL No. 634R SWITCH ON REGULATOR Suitable for Calor Switch-on (21 mm) Gas Bottle Connecting the cylinder ROTATE the plastic cap on the CYLINDER VALVE until PULL the lanyard out, then upwards. The cap will lift off the arrow points out through the gap in the valve shroud. the valve. Do not use tools. Leave the cap hanging down from the valve while the cylinder is in use. Assembly on the gas cylinder OPEN Handle vertically flame On Make sure that: -all taps on the consuming appliace are closed; -the connecting pipe to the appliance is correctly fitted; -The Quick-on regulator handle is in the closed position (fig. 3). With no flame on, remove the seal cap on the cylinder automatic valve, place the Quick-on onto the automatic valve and push down firmly and vertically. You will hear a “click” sound which means the regulator is securely latched (fig. 4). Note: Quick-on is so designed as to prevent it from being fitted to the valve, unless the regulator handle is in the closed position; therefore, never attempt to mount or dismount fig.3 it, if the handle is not in this position. Operation Once the Quick-on is correctly mounted on the valve, gas supply is possible by turning the regulator handle upwards (counterclockwise). To shut off the gas supply, reverse above procedure; an arrow engraved on the handle indicates the closing direction (fig.3). Symbols engraved on the bonnet show how to operate the regulator handle. CAUTION: if you are unable, to open the regulator handle, this means that your Quikon is not correctly connected to the valve. Do not force the handle to open, instead start again the operations described above in 3. Replacement of a cylinder Make sure that: -all taps on the consuming appliance are in the closed position. -the Quick-on regulator handle is in the closed position. Then, dismount the Quick-on by pressin...
Dieses Handbuch ist für folgende Modelle:elektrische Heizungen - 634R (470.92 kb)