Stimmen - 2, Durchschnittliche Bewertung: 4 ( )

Hersteller: United States Stove Dateigröße: 1.27 mb Dateiname: Unterrichtssprache:

Replacement of Glass Replacing parts Surface Finish Trouble Shooting Fire Not Burning A stove not burning is generally caused by either a shortage of air and/or incorrect or damp fuel. If fuel is not the problem check: • That the air controls are opened. • There is no blockage in the flue system. • That the open end of the flue is above the height of any nearby obstructions. • That there is a sufficient air supply into the room and that this supply is not being taken by an extractor fan. Glass usually blackens when: • The fuel is not being burned efficiently because of starvation of air. • Bad quality or damp fuel is being used. • Balance between primary and secondary air is incorrect. Try to introduce more air into the stove, especially through the secondary air control on the top of the stove door as this air flows down over the glass to help burn off the creosote. For optimum efficiency always use a good quality wood. Glass Blackens If the stove is properly installed it should not emit any smoke into your room. Should this happen, Check that your room is not air tight. This can easily be checked by opening a door or window. If the smoking stops you need to provide an additional air supply into the room. If this is not the problem, check if your chimney is blocked or obstructed and that you are not getting a down draft caused by the location of the open end of the flue pipe or chimney. If the problem persists contact your dealer and ask him to get your chimney and stove installation checked. This is usually caused by too much draft or air. • Firstly try reducing the air supply to the stove by closing down your air controls, if this fails then you may have damage to the sealing. • Check the condition of the door sealing rope and the joints within the stove. If neither of these solve the problem you may have too much draft on your chimney and you may need to fit a damper valve into your flue system. You should not install a flue damper without consulting a specialist. Never install a damper that can completely block your flue or chimney. Contact your dealer to discuss this. Chimney fires occur when soot and creosote that have built up in the flue system ignite. If the stove is operated properly and the flue checked and cleaned regularly then chimney fires should not occur. These fires can be very dangerous and must be avoided. Try to maintain good, hot fires in the stove whenever possible and at least once in every firing open the air controls and allow the stove to burn on full for a short while until the entire fire bed is glowing red. Check your flue system regularly for build-up of soot and creosote and clean as necessary. Chimney fires can be detected by sparks coming from the top of the chimney, a roaring sound coming from the area of the stove or chimney or vibration in the stove or chimney. In the event of a chimney fire, close the air controls, evacuate the building and call the fire department. Do not relight the stove after a chimney fire until the stove and flue have been checked and any necessary repairs have been carried out. Smoke in Room Fire Burns too Quickly Fire Burns too Quickly Warranty Policy & Procedures U.S. Stove offers the original retail purchaser of the Solid Fuel burning products a limited 5-year warranty. The following outlines the U. S. Stove's Warranty programs. U. S. Stove Limited Warranty This warranty applies to the original retail purchaser only. U. S. Stove warrants that this stove will be free of defects in material and workmanship for a period of five years from the date of purchase. U. S. Stove will repair or replace (parts and labor) at its option, any stove or part thereof found to be defective. You must arrange to deliver or ship the stove or part to an authorized U. S. Stove dealer at your own expense and arrange for pickup or delivery of the same after the repairs have been made. If, upon inspection, any damage is found to be the fault of the manufacturer, the repair or replacement will be made. This warranty does not include expenses incurred from travel time or loss of service. This warranty is not transferable and is extended only to, and is solely for the benefit of, the original retail purchaser of the stove. Please keep your dated sales receipt as proof of purchase. Exclusions and Limitations This warranty does not cover the following: 1. Repair or replacement of parts, which are subject to normal wear and tear during the warranty period or to parts that may require replacement in connection with normal maintenance. These parts include paint, gaskets, burn plates, baffles, fire grates or glass (glass is only warranted against thermal breakage). 2. Damage due to incorrect installations not in conformance with the manufacturer’s installation instructions or local and national regulations. It is the responsibility of the installer to ensure that the unit is installed and operating correctly at the time of installation. 3. Damage caused by over-firing, which ca...

Herunterladen

Geben Sie zwei Ziffern: