Stimmen - 3, Durchschnittliche Bewertung: 4.3 ( )

Hersteller: Dimplex Dateigröße: 904.49 kb Dateiname: Unterrichtssprache:

Fit the castors to the stub axles by applying hand pressure until each castor clicks into position - see Fig. 3. Note that the castors are designed to be a tight fit on the axles but will rotate in use. The castors can only be fitted between the outer fins (as shown in Fig. 2). Turn the radiator upside down on a carpet or other soft surface to avoid damage WARNING : THE RADIATOR IS HEAVY – ENSURE THAT IT IS SUPPORTED TO PREVENT IT FROM TOPPLING. Ask a second person to help with this if necessary. Position castor bracket (see Fig. 3) onto the threaded pins on the control panel. Place the winged nut ‘C’ on the thread and tighten it securely. Repeat the process for castor bracket ‘B’ onto the last fin. Note: The 5 fin column radiator models - OFRC10 & OFRC10TI use curved castor brackets and must be fitted as shown in Fig. 2. Lift the radiator clear of the floor, then turn it back upright and stand it on its castors as shown in Fig. 1. It is now ready for use. Positioning the Heater Select the position for the radiator ensuring there is clearance from any furniture and fittings of at least 300mm above the heater and 150mm each side. The radiator should only be operated on a flat stable surface. Operation IMPORTANT – Objects or clothing must not be placed on this heater. Before using the heater ensure that all warnings and instructions have been read carefully. To bring the heater into use plug it in. Neon indicating lights located at the controls area will glow when the appliance is plugged into the mains. Controls Thermostat (see Fig. 4) The Thermostat (see Fig. 4) controls the heat output according to the room temperature. This ensures that the heater will not produce heat unnecessarily when the room is warm. To set the temperature you require, turn the thermostat knob clockwise until the required setting is reached. Alternatively to heat a cold room quickly, turn the thermostat knob up fully. When the room has reached the desired temperature, turn the thermostat knob anti-clockwise until the thermostat just clicks off. The heater will now automatically operate at this temperature. The thermostat also has a frost protection setting marked ‘ ‘. This setting is useful in areas such as garages, to prevent frost damage. If the thermostat is set to its minimum setting ‘ ’, the heater will cycle on and off to maintain a temperature of approximately 5° to help protect against frost. Note – Should the heater fail to come on when the thermostat is at a low setting, this may be due to the room temperature being higher than the thermostat setting. Heat Selector Switches (see Fig. 5) Selector switches located on the control panel provide a choice of heat output to suit varying conditions and for economy of operation. Table 1 Model Switch Switch OFRC10/OFRC10TI 700W 1000W OFRC15/OFRC15TI 1000W 1500W OFRC20/OFRC20TI 1400W 2000W OFRC25/OFRC25TI 1700W 2500W Digital Timer Operation (see Fig. 6) IMPORTANT: Remember to observe all safety warnings when operating the h...

Herunterladen

Geben Sie zwei Ziffern: