Stimmen - 4, Durchschnittliche Bewertung: 3.8 ( )

Hersteller: Cadet Dateigröße: 222.71 kb Dateiname: Unterrichtssprache:

3. Power can be restored once cleaning work is complete. Troubleshooting Chart CONSULT LOCAL ELECTRICAL CODES TO DETERMINE WHAT WORK MUST BE PERFORMED BY QUALIFIED ELECTRICAL SERVICE PERSONNEL Symptom Problem Solution Snapping noise 1. Unit may have a loose end plate 2. Heater may not be mounted properly 1. Loosen end plate screws . turn after allowing heater to warm, move end plate back and forth, then tighten 2. Loosen heater from wall by turning mounting screws . turn Heater not working 1. Heater does not have proper voltage to function correctly 2. Loose wire connections 3. Incorrect circuit breaker 4. Defective limit 1. Check voltage at the heater between supply wires and make sure it matches required heater voltage 2. Tighten any loose wire connections 3. Circuit breaker positioned incorrectly - relocate breaker 4. Replace limit Heater will not shut off 1. Heat loss from room is greater than heater capacity 2. Defective thermostat 3. Thermostat wired incorrectly to heater 4. Temperature in room lower than thermostat’s lowest setting 1. Close doors and windows. Provide additional insulation, install a higher- wattage heater or multiple heaters if necessary 2. Adjust thermostat to its lowest setting. If heater continues to run (allow two minutes for the thermostat to respond), replace thermostat 3. Refer to thermostat documentation and correct wiring 4. Change thermostat to double pole model with positive off (single pole thermostats have a minimum temperature setting with no “off” position). Black streaks (sooting) 1. Excessive hydrocarbons present in 1. Remove/reduce use of items emitting hydrocarbons. (Common sources: depositing on baseboard, home environment* insect foggers, aerosol sprays, carpet cleaning chemicals, candles, plants, walls, and drapes 2. Not enough fresh air flowing through baseboard 3. Streaking being allowed to build up on room surfaces dust, cigarette smoke and fireplaces) 2. Increase amount of fresh air available in room. Do not use heater during any chemical usage (insect fogging, carpet cleaning, etc.) and allow for outside air exchange before re-use of heater(s) 3. More frequent cleaning of streaking to reduce amount of build-up * Black soot and residue is formed by the combustion of hydrocarbons. Existing hydrocarbons in environment pass through heater element and scorch, exit the heater and deposit on walls and room surfaces. Note: The heater itself does not produce/release any hydrocarbons. WARRANTY Maintenance: For more effective and safer operation and to prolong the life of the heater, read the Owner’s Guide and follow the maintenance instructions included with each heater. Failure to properly maintain the heater will void any warranty and may cause the heater to function improperly. Warranties are non transferable and apply to original consumer only. Warranty terms are set out below. LIMITED LIFETIME WARRANTY: Cadet will repair or replace any Cadet baseboard (F) found to be defective at any time. THESE WARRA...

Herunterladen

Geben Sie zwei Ziffern: