Stimmen - 6, Durchschnittliche Bewertung: 4.2 ( )

Hersteller: Saab Dateigröße: 239.14 kb Dateiname: Unterrichtssprache:

30 06 665, or equivalent, to the heating element O- ring. 20 Fit the heating element so that the electrical connection is directed towards the left-hand side of the car and the connection is between the coolant pipes and under the turbocharger coolant pipe. Do not tighten the nut holding the heating element. 21 Adjust the position of the heating element so that it is free from contact with the coolant pipes. Tighten the nut. Tightening torque 3.5 Nm (2.5 lbf ft) Connect and secure the cable to the lower oxygen sensor. 22 Apply acid-free petroleum jelly, part no. 30 15 286 or equivalent, to the O-ring on the supply connector cable and connect the cable to the heating element. 23 Fit the lock clip over the connection. A click should be heard when the lock clip is fitted correctly. 24 Aut: Secure the supply connector cable to the lower cable by the battery tray with the clips included in the kit. Man: Secure the supply connector cable to the left-hand structural member with a strap. WARNING Make sure that the cable does not make contact with sharp edges or hot surfaces. Be aware of the turbo unit. Scrapes and heat damage can cause a short-circuit. Saab 9-5 B205, B235 8 53 29 271 25 Check the ground connection between the ground pin on the connector plug, the heater casing and the car body. 26 Fit the heat shield, lubricate the bypass pipe O- ring with acid-free petroleum jelly and fit the turbocharger delivery pipe, including the bypass pipe. Connect the vacuum hose to the bypass pipe and the hoses and connector to the turbocharger delivery pipe. Fit the engine cover. 27 Fill up with coolant and check the system for leaks. 28 Bleed the cooling system in the following way: Note The A/C or ACC should be turned OFF. Fill the coolant system to the MAX level. Close the expansion tank cap. Start the engine and run to operating temperature at varying engine speeds until the radiator fan cuts in. Carefully open the expansion tank cap and top up to the MAX level. Close the cap. Switch off the engine and if necessary top the coolant up to the MAX level. 29 Check that the cooling system does not leak and that the heater works. 30 Place the installation instructions in the car and draw the customer's attention to the user instructions. Saab 9-5 B205, B235 53 29 271 9 BA E930A073 A Branch cable set B Timer kit Saab 9-5 B205, B235 10 53 29 271 User instructions • The extension cable must be made of oil-resistant rubber and approved for outdoor use with a cross-sectional area of at least 3x1.5 mm2. • The engine heater must be connected to a grounded outlet only. • Handle all cables with care. Pay particular attention to the risk of pinching between the bonnet and the body of the car and the risk of cuts on sharp metal components. WARNING Check regularly the ground connection between the ground pin in the connector plug, the heater casing and the car body. • Inspect regularly the extension cable for damage or ageing. Damaged cables must be renewed immediately. Note The function of the heater will be at risk if: • there are impurities in the coolant • the coolant level is too low or if there is air in the system • there is ice slush in the system • radiator sealant is used Saab 9-5 B205, B235 ...

Herunterladen

Geben Sie zwei Ziffern: