Stimmen - 2, Durchschnittliche Bewertung: 5
(
)
)
|
Anleitung Zusammenfassung
INTRODUCTION This section provides the installation instructions for the Henny Penny Heated Merchandiser. Installation of this unit should be performed only by a qualified service technician. Do not puncture the heated merchandiser with any objects such as drills or screws as component damage or electrical shock could result. 2-2. UNPACKING The Henny Penny Heated Merchandiser is tested, inspected and expertly packed to ensure arrival at its destination in the best possible condition. The unit has been bolted to wooden skid. All items have been packed and taped inside of the unit. The unit is then packed inside a triple wall corrugated carton with sufficient padding to withstand normal shipping treatment. Any shipping damage should be noted in the presence of the delivery agent and signed prior to his or her departure. To remove the heated merchandiser from the carton, you should: 1. Carefully cut banding straps. 2. Open flaps of carton and remove packing. 3. Lift carton from unit. 4. Remove four bolts mounting the merchandiser to the skid. 5. If installing the unit on a merchandiser base, use existing bolts to mount unit. 6. Unpack doors, cutting board, and pan supports, and install. 7. The heated merchandiser is now ready for location and setup. 203 2-1 Model HMR-103,104,105,106,107 2-3. ELECTRICAL CONNECTION NEMA NUMBERS: Model 208/240-1 ph 208-3 ph 240-3 ph 107 106 105 104 103 14-50P 14-50P 14-50P L14-30P L14-30P L21-30P L21-30P L21-30P L21-20P L21-20P Hardwire Hardwire Hardwire Hardwire Hardwire The heated merchandiser is available from the factory, wired for 120/208-240 volts, single or three phase, (includes neutral), 220-240 volts, or 380-415 volts. Refer to the table at left, and bottom, for proper power connection. International units are not supplied with cord and plug, and must be provided upon installation. If two CE units are placed side-by-side, a grounding wire needs to be placed between the equipotential bonding lugs, located under the cutting board brackets, of both units. This unit must be adequately and safely grounded. Refer to local electrical codes for correct grounding procedures. If heated merchandiser is not adequately grounded, electrical shock could result. (FOR EQUIPMENT WITH CE MARK ONLY!) To prevent electric shock hazard this appliance must be bonded to other appliances or touchable metal surfaces in close proximity to this appliance with an equipotential bonding conductor. This appliance is equipped with an equipotential lug for this purpose. The equipotential lug is marked with the following symbol A separate disconnect switch with proper capacity fuses or breakers must be installed at a convenient location between the unit and the power source. 2-2 1004 Model HMR-103,104,105,106,107 2-4. ELECTRICAL DATATABLE MODEL COMBINATION VOLTS KW AMPS MODEL COMBINATION VOLTS KW AMPS 1 PHASE 3 PHASE1 PHASE 3 PHASE HMR-107 7S 120/208 5.0 24 18 HMR-107 3F/2S/2F* 120/208 6.0 29 19 6.7 32 22 7.8 37 23 120/240 5.0 16 16 120/240 6.0...
Dieses Handbuch ist für folgende Modelle:elektrische Heizungen - HMR-104 (656.35 kb)
elektrische Heizungen - HMR-105 (656.35 kb)
elektrische Heizungen - HMR-106 (656.35 kb)
elektrische Heizungen - HMR-107 (656.35 kb)