Stimmen - 4, Durchschnittliche Bewertung: 4.5 ( )

Hersteller: Cadet Dateigröße: 9.01 mb Dateiname: 7bb2937f-eaaa-6674-3533-0a2470263db3.pdf Unterrichtssprache:

GENERAL INFORMATION Qualified Installing Agency Installation and replacement of gas piping, gas utilization equipment or accessories and repair and servicing of equipment shall be performed only by a qualified agency. The term "qualified agency" means any individual, firm, corporation, or company that either in person or through a representative is engaged in and is responsible for(a)theinstallation,testing,or replacementofgaspipingor(b)the connection, installation, testing, repair, or servicing of equipment; that is experienced in such work; that is familiar with all precautions required, and that has complied with all the requirements of the authority having jurisdiction. The installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/ NFPA54.* *Available from the American National Standards Institute, Inc. 11 West 42nd St., New York, N.Y. 10018. State of Massachusetts: The installation must be made by a licensed plumber or gas fitter in the Commonwealth of Massachusetts. Sellers of unvented propane or natural gas-fired supplemental room heaters shall provide to each purchaser a copy of 527 CMR 30 upon sale of the unit. In the State of Massachusetts, unvented propane and natural gas-fired space heaters shall be prohibited in bedrooms and bathrooms. 20171-3-0907 Page 3 Page 4 20171-3-0907 PROPER INSTALLATION SEQUENCE: LS-(18, 24, 30)RSS (Figure 1) 1. Place left, rear (#1) log onto left, rear pin on rear log support. 2. Place right, rear (#2) log onto right, rear pin on rear log support. 3. Place left, front (#3) log onto two (2) left, front pins on burner pan. 4. Place right, front (#4) log onto two (2) right, front pins on burner pan. 5. Insert boss on left, top (#5) log into recess on left side of left, rear (#1) log and onto left side of left, front (#3) log. 6. Insert boss on center, top (#6) log into recess on right side of left, front (#3) log. 7. Insert round boss and square recess on (#7) right, top log into recess and boss on center, top (#6) log. 8. Compare the completed log installation with the appropriate photo from pages 5 through 7. Review previous steps to make any necessary adjustments. 9. Log placement is completed. Attention: Do not use Figure 1 to order replacement logs. Refer to Page 12 Parts List and Parts View to order logs for your appropriate model number. Apply loose material (glowing embers) per appropriate Installation Instructions and Owner's Manual. Replacement of loose material (glowing embers) must be purchased from Empire Comfort Systems, Inc. Application of excess loose material (glowing embers) may adversely affect performance of the heater. WARNING: All previously applied loose material must be removed prior to reapplication. Replacement Loose Material (glowing embers) Part Number LS-18RSS 15999 LS-24RSS 15970 LS-30RSS 15970 Platinum Bright Embers PE20-1 Note: A single layer of embers is to be used when applying Platinum Bright Embers (alone or in ...

Herunterladen

Geben Sie zwei Ziffern: