Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Dieses Gerät hat auch andere Anweisungen:
Babyphone - SCD570/10 (440.2 kb)
Stromerzeuger - SCD570/10 (1.61 mb)
Stromerzeuger - SCD570/10 (323.15 kb)
Anleitung Zusammenfassung
• Perhaps the non-rechargeable batteries of the
12 Guarantee and
baby unit are empty and the baby unit is not
connected to the mains. Replace the non-
support
rechargeable batteries or connect the baby unit
to the mains. Then press the on/off button to
If you need information or support, please visit the
establish connection with the parent unit.
Philips website at www.philips.com/support
• If the ‘link’ light on the parent unit still does not
or or contact the Philips Consumer Care Centre
start flashing red, use the reset function to reset
in your country (see the worldwide guarantee
the units to their default settings.
leaflet for contact details). If there is no Consumer
Care Centre in your country, go to your local
Why does the ‘link’ light on the parent unit flash
Philips dealer or a Philips service centre.
red continuously and why is the message ‘NOT
LINKED’ or ‘I AM LINKING’ shown on the
display?
• The baby unit and the parent unit are out
13 Frequently asked
of range of each other. Move the parent unit
closer to the baby unit.
questions
• The baby unit may be switched off. Switch on
the baby unit.
This chapter lists the questions most frequently
asked about the appliance. If you cannot find the
Why does the battery status light on the baby
answer to your question, visit www.philips.com/
unit flash red?
support for more frequently asked questions
• The non-rechargeable batteries of the baby unit
or contact the Consumer Care Centre in your
are running low. Replace the non-rechargeable
country.
batteries or connect the baby unit to the mains
(see chapter ‘Preparing for use’).
What is Eco Max mode? How does this mode
help the environment?
Why does the parent unit beep?
• The Eco Max mode has been developed to
• If the parent unit beeps while the ‘link’ light
enable you to reduce the energy consumption
flashes red continuously and the message ‘NOT
of your baby monitor. When you monitor your
LINKED’ or ‘I AM LINKING’ is shown on the
baby from a small distance, you can activate the
display, the connection with the baby unit is lost.
Eco Max mode. By switching on the Eco Max
Move the parent unit closer to the baby unit or
mode, your baby monitor uses less energy and
switch the baby unit on, if it was off.
is therefore more environment-friendly.
• If the parent unit beeps and the battery symbol
on the display is empty, the rechargeable
Why don’t the power-on light of the baby unit
batteries of the parent unit are running low.
and the ‘link’ light of the parent unit come on
Recharge the batteries.
when I press the on/off buttons of the units?
• If you have set the room temperature range on
• Perhaps the rechargeable batteries of the
the parent unit and the temperature alert is on,
parent unit are empty and the parent unit is not
the parent unit beeps when the temperature
plugged in. Insert the small appliance plug into
drops below the set minimum temperature
the charger and put the adapter in a wall socket.
range or when the temperature rises above the
Place the parent unit in the charger. Then press
set maximum temperature range.
the on/off button to establish connection with
• The baby unit may be switched off. Switch on
the baby unit.
the baby unit.
22
...