Stimmen - 2, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
. Only use the powerplug supplied. . The powerplug transforms 100-240 volts to a safe low voltage of less than 24 volts. . The powerplug contains a transformer. Do not cut off the powerplug to replace it with another plug, as this will cause a hazardous situation. . Do not use a damaged powerplug. . If the powerplug is damaged, always have it replaced by one of the original type in order to avoid a hazard. . Make sure the powerplug does not get wet. . Charge and store the appliance at a temperature between 5cC and 35cC. C . Never immerse the charging stand in water nor rinse it under the tap. . Do not recharge the shaver in a closed pouch. . Always unplug the shaver before cleaning it under the tap. C . The appliance complies with the internationally approved IEC safety regulations and can be safely cleaned under the tap. Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt. . Noise level: Lc = 64 dB [A] 4222 002 48152 08-11-2006 14:32 Pagina 5 ENGLISH 5 Charging Make sure the appliance is switched off before you start charging it. Charging normally takes approx. 1 hour. You can also shave without charging by connecting the shaver to the mains. Charge indications Charging C . When you start charging the empty shaver, the bottom light burns red.When the battery contains enough power for one shave, all lights start blinking green sequentially. Battery fully charged C . When the battery has been fully charged, all green light are on. A few hours after charging, all lights go out. Remaining battery capacity C . The amount of power left in the battery is indicated by the number of lights that are on. C 4222 002 48152 08-11-2006 14:32 Pagina 6 6 ENGLISH The remaining battery capacity is shown when you unplug the shaver or when you switch it on or off: -When all lights burn green, the battery is 100% charged. -When the bottom light burns green, 20% of the battery capacity is left. Battery running low C . When the battery is running low, the bottom light starts burning red. When you switch the shaver off, this light blinks a few times. Cordless shaving time A fully charged shaver has a cordless shaving time of up to 80 minutes. Charging the appliance 1 2 3 Put the appliance plug in the shaver. Put the powerplug in the wall socket. Remove the powerplug from the wall socket and pull the appliance plug out of the shaver when the battery has been fully charged. C C 4222 002 48152 08-11-2006 14:32 Pagina 7 ENGLISH 7 Charging stand You can also charge the appliance by placing it in the charging stand, if provided. Never immerse the charging stand in water nor rinse it under the tap. C . Place the shaver properly in the plugged-in charging stand. The bottom light starts burning red. C . Lift the shaver from the stand without tilting it. Removing and inserting the clock 1 Turn the clock anticlockwise (1) ('click') and pull it out (2). 2 Insert the clock (1) and turn it clockwise (2) ('click'). 4222 002 48152 08-11-2006 14:32 Pagina 8 C . Set the time by pressing the small button at the back of the clock. C C -You can set the shaver to 'Normal' for a fast and comfortable close shave. C . The Personal Comfort Control system allows you to adapt the shaver to your skin type. -You can set the shaver to 'Sensitive' for a comfortable close shave with optimal skin comfort. 8 ENGLISH Setting the time The time can only be set forward. Replacing the battery 1 Remove the cap.Then remove the battery by means of a miniature screwdriver. 2 Insert a new battery and put the cap back into place. Using the appliance Personal Comfort Control C C 4222 002 48152 08-11-2006 14:32 Pagina 9 ENGLISH 9 C . The 'S' position is best suited for sensitive skin. C . The 'N' position is best suited for normal skin. . The in-between positions are suitable for skin types between normal and sensitive. Shaving 1 Switch the shaver on by pressing the on/off button once. When you switch the shaver on or off, all lights and symbols go on and then the remaining battery capacity is shown for a few seconds. 2 Move the shaving heads quickly over your skin, making both straight and circular movements. -Shaving on a dry face gives the best results. -Your skin may need 2 or 3 weeks to get accustomed to the Philips system. 3 4 Switch the shaver off by pressing the on/off button once. Put the protection cap on the shaver every time you have used it, to prevent damage. C C 4222 002 48152 08-11-2006 14:32 Pagina 10 10 ENGLISH Trimming For grooming sideburns and moustache. 1 Open the trimmer by pushing the slide downwards. The trimmer can be activated while the motor is running. 2 Close the trimmer with your index finger. Cleaning and maintenance C . The tap symbol starts blinking after every shave to remind you that the shaver needs to be cleaned (except when the bottom light burns red). Regular cleaning guarantees better shaving performance. . If provided, use the washing machine to clean the shaver. See the seperate...
Dieses Handbuch ist für folgende Modelle:Rasierer - HQ9160/16 (6.76 mb)