Stimmen - 3, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
Replacing the system outer foil (see fig. 9) Squeeze the system outer foil release buttons and lift the system outer foil upward to remove it. To insert the new system outer foil, press down until it snaps into place. Replacing the inner blades (see fig. 10) Squeeze the system outer foil release buttons and lift the system outer foil upward to remove it. Remove the inner blade one at a time by grasping it firmly at both ends and pulling straight away from the shaver. Do not touch the metal parts of inner blades. To insert the new inner blade, hold the blade one at a time at both ends and press downward until it snaps into the shaver. ATTENTION: 2 nickel metal hydride batteries that are recyclable power the product you have purchased. Please call 1-800-8-BATTERY for information on how to recycle the batteries. 9 Caution – To prevent personal injury or damage to the product, • Do not charge the shaver where the temperature is below 5° C (41° F) orHow to remove the built-in above 35° C (95° F), where it will be rechargeable batteries before exposed to direct sunlight or a heat disposal of the shaver source, or where there is a lot of (see fig. 11) moisture. The batteries in this shaver are not • Use only the included adaptor intended to be replaced by consum RE7-05 to charge the ES8151/ ers. However, the batteries may be ES8152 shaver. replaced at an authorized service • Dry the shaver completely before center. The procedure described be- charging it. low is intended only for removal of • Keep the adaptor away from water the rechargeable batteries for the and handle it only with dry hands. purpose of proper disposal. • The charge status lamp may not 1. Remove the screw (a) and the glow for several minutes after bottom cover (b). charging has commenced but will 2. Slide the trimmer handle up until glow if charging is continued. it clicks in. • Grip the adaptor when disconnect3. Remove the screw (c) and the ing it from an AC outlet; tugging on panel cover (d). the power cord may damage it. 4. Remove the six screws (e). • Store the adaptor in a dry area 5. Remove the back panel (f). where it will be protected from dam 6. Lift the battery block (g) and re- age. move it from the battery terminal • Do not pull, twist, or severely bend sealing (h). the power cord. 7. Remove the batteries from the • Do not wrap the power cord tightly battery block (g). around the appliance. WARNING: • The linear motor of the shaver may Do not attempt to replace the bat- start operating without the On/Off teries for the purpose of reusing switch on if the shaver is placed the shaver. This could result in the near a television, stereo, audio- risk of fire or electric shock. visual equipment or anything that generates strong magnetic field. Do not place the shaver near these equipments. • Wash the shaver in tap water. Do not use salt water or boiling Also, do not use 10 that are designed for toilets, bathrooms or kitchen appliances. Do not submerge the shaver for a long time. • Do not wipe any part of the shaver with thinner, benzine or alcohol. Clean it by using a cloth dampened with soapy water. • Do not take the housing apart as this can affect the watertight construction. • Do not clean with water when the shaver is connected to the power cord. • Do not shave when the “ sonic” vibration is activated, as it may damage your skin. • When cleaning the shaver with water, do so with both the inner blades attached. (Doing so with only one of the inner blades attached makes an abnormal noise and may damage the shaver. ) Specifications Power source: 100-240V AC, 50-60 Hz (Automatic voltage conversion) Motor voltage: 2.4 V DC Charging time: 1 Hour This product is intended for household use only. FOR YOUR CONVENIENCE, WE HAVE ESTABLISHED A TOLL-FREE (IN USA ONLY) NATIONAL ACCESSORY PURCHASE HOT LINE AT 1-800-338-0552. FOR CANADA, PLEASE CONTACT ONE OF THE SALES BRANCHES MENTIONED THE BACK PAGE. 11 INSTRUCTIONS DE SECURITE IMPORTANTES Lors de l’utilisation d’un appareil compris les points suivants: electrique, les precautions de base Lisez toutes les instructions avant doivent toujours etre respectees, y d’utiliser cet appareil. Afin de reduire tout risque de decharge DANGER electrique: 1. Ne touchez pas l’appareil s’il est tombe dans l’eau. Debranchez-le immediatement. 2. Il ne faut pas placer ou ranger le cordon d’alimentation la ou il peut tomber dans une baignoire ou un evier. Ne deposez ou n’echappez pas dans l’eau ou dans un autre liquide. 3. Avant de charger le rasoir, essuyez toute trace d’humidite du rasoir et du cordon d’alimentation. Manipulez MISE EN GARDE 1. N’utilisez pas ce rasoir avec des lames de rasage, et/ou une grille endommagees, car des blessures du visage risquent de se produire. 2. Une grande vigilance est necessaire lorsque ce rasoir est utilise par des enfants ou des invalides, sur eux ou en leur presence. 3. Utilisez cet appareil uniquement pour son usage prevu, comme le decrit le present manuel. N’utilisez pas d’acces...