Stimmen - 3, Durchschnittliche Bewertung: 4.3
(
)
)
|
Anleitung Zusammenfassung
Regular cleaning will keep your shaver in good condition while preventing odors or bacteria from developing, and maintain the cutting performance. With the system outer foil in place, apply some hand soap onto the outer foil. Turn the shaver on and pour some water over the outer foil. After about 10-20 seconds, turn the shaver off. Remove the system outer foil and clean it with running water. Wipe off any moisture from the shaver with a dry cloth and remove the protective cap to allow the system outer foil to dry completely. 7 Replacing shaving head components It is recommended that you replace the outer foil at least every year and the inner blade at least every two years to maintain your shaver’s cutting performance. Replacing the system outer foil {see fig. 7) Squeeze the system outer foil release buttons and lift the system outer foil upward to remove it. To insert the new system outer foil, press down until it snaps into place. Replacing the inner blades (see fig. 8) Squeeze the foil frame release buttons and lift the foil frame upward to remove it. Remove the inner blade one at a time by grasping it firmly at both ends and pulling straight away from the shaver. To insert the new inner blades, hold the blade one at a time at both ends and press downward until it snaps into place. Caution • Do not charge the shaver where the temperature is below 0°C {32°F) or above 40°C (104°F), where it will be exposed to direct sunlight or a heat source, or where there is a lot of moisture. • Use only the included shaver charging adaptor RE3-78 to charge the ES8065/ES8066 shaver. • The supply cord of the charging adaptor cannot be replaced; if the cord is damaged, the entire charger should be discarded. • Dry the shaver completely before setting it in the charging adaptor. • Keep the charging adaptor away from water and handle it only with dry hands. Do not use an extension cord to connect the charging adaptor to an outlet. • The shaver may not immediately begin to charge after being placed into the charging adaptor after use. Allow the shaver to sit in the charging adaptor for a few minutes and check again to make sure that it is being charged. • Do not place any metal objects like coins and paper clips on the charging adaptor as they will become warm. • Grip the plug when disconnecting the charging adaptor from a receptacle; tugging on the cord may damage it. • Store the charging adaptor and its cord set in a dry area where it will be protected from damage. • The linear motor of the shaver may start operating without the power switch on if the shaver is placed near a television, stereo, audio/ visual equipment or anything that generates a strong magnetic field. • The outer foil is very thin. If handled improperly, it can be easily damaged.To avoid personal injury, do not use the shaver if it has a damaged foil or inner blade. • Wash the shaver in tap water. Do not use salt water or boiling water. Also, do not use cleaning products that are designed for toilets, bathrooms or kitchen appliances. Do not submerge the shaver for a long time. • Do not wipe any part of the shaver with thinner, benzine or alcohol. Clean it by using a cloth dampened with soapy water. • Do not take the housing apart as this can affect the watertight construction. Specifications Power source: 100-120/220-240V AC, 50-60 Hz (Automatic voltage conversion) Motor voltage: 2.4 V DC Charging time: 12 Hours This product is intended for household use only. READ ALL INSTRUCTIONS BEFORE USE. FOR YOUR CONVENIENCE, WE HAVE ESTABLISHED ATOLL-FREE (IN USA ONLY) NATIONAL ACCESSORY PURCHASE HOT LINE AT 1-800-338-0552. FOR CANADA, PLEASE CONTACT ONE OF THE SALES BRANCHES MENTIONED ON THE BACK PAGE. 9 INSTRUCTIONS DE SÉCURITÉ IMPORTANTES Lors de l’utilisation d un appareil compris les points suivants: électrique, les précautions de base Lisez toutes les instructions avant doivent toujours être respectées, y d’utiliser cet appareil. DANGER Afin de réduire tout risque de décharge 1. Ne installez pas l’appareil dans des endroits où il peut tomber dans une baignoire ou un évier. 2. Ne touchez pas l’appareil s’il est tombé dans l’eau. Débranchez-le immédiatement. 3. DNe placez pas ou ne rangez pas l’adaptateur de charge dans des endroits où il peut tomber dans une baignoire ou un évier. Ne le mettez pas ou ne le faîtes pas tomber dans l’eau ou un autre liquide. MISE EN GARDE 1. N’utilisez pas ce rasoir avec des lames de rasage et/ou une grille endommagée, car des blessures du visage risquent de se produire. 2. Une surveillance sévére est nécessaire lorsque ce rasoir est utilisé sur des enfants, ou en présence d’enfants ou d'invalides. 3. Utilisez cet appareil uniquement pour l’usage pour lequel il est destiné tel que décrit dans ce mode d'emploi. N’utilisez pas des accessoires qui ne sont pas recommandés par le fabricant. 4. N’utilisez jamais cet appareil si le cordon ou la fiche est endommagé, s’il ne fonctionne pas c...