|
Anleitung Zusammenfassung
• ALLOW FOR PROPER VENTILATION WHEN UNITS ARE IN USE. Do not cover the Nursery Unit or Parent Units with any object such as a blanket. Do not place it in a drawer or in any location which would muffle the sound or interfere with the normal flow of air. • DO NOT immerse any part of the Nursery Monitor in water. Clean only with a dry cloth. • DO NOT place unit near water and moisture. Do not use the Nursery Unit outdoors. Do not use the monitor near possible wet areas, such as a bathtub, shower, wash basin, sink, laundry tub, swimming pool, wet basement, etc. • KEEP NURSERY MONITOR AWAY FROM HEAT SOURCES, such as fireplaces, radiators, stoves, and TVs or other appliances. Heat can damage the case or electrical parts. • DO NOT use the monitor if: • The adapter cords or plugs have been damaged. • The unit has been exposed to liquids. • Unit has been dropped or is damaged. • DO NOT OPEN THE TRANSMITTER, RECEIVER OR ADAPTER. No user-serviceable parts inside. Risk of electrical shock, fire or death. 907-2-02 5 • Remove batteries from Parent’s Unit if it will not be used for a long time. • Remove a dead battery promptly. A dead battery left in unit may leak, damaging your unit. • Do not attempt to recharge a non-rechargeable battery. • A rechargeable battery CANNOT be recharged by plugging AC adapter into the Parent’s Unit. Remove the battery from unit to recharge it. • Charging of a rechargeable battery should only be done by an adult. • Battery power will be conserved when Parent’s Unit is powered through AC adapter. It is not necessary to remove battery when using AC adapter. • Change battery if: • Signal reception becomes poor. • Static noise develops (also check for appliance interference). System Setup Installing a Battery Battery Use Tips The Parent Units can be operated on 4—1.5V “AAA”/LRO3 battery power. Alkaline batteries are recommended. Battery changing should only be done by an adult. 1 2 1 2 907-2-02 6 Using AC Adapters • The Parent Units can use either 4—1.5V “AAA”/LRO3 batteries or standard 120 volt AC household current. The Nursery Unit uses standard 120 volt AC household current only. The included AC adapters must be used for this purpose. • To use AC adapters, plug the connector on the cord into the AC adapter jack on the side of the unit. Then plug adapter into a standard wall outlet. • Use ONLY the Graco adapters included with the monitor. Do not use these adapters with other equipment under any circumstances. • If units do not work, check that AC adapters are plugged into working outlets. • When electricity is off (from a power failure, etc.), the Nursery Unit will NOT work, since it only operates on AC current. Selecting Channels • Check that both Nursery Unit and Parent ’s Unit are set to the same channel. • To change channel, slide Channel button to either A, B, X, or Y on BOTH units. Setting Up the Baby Monitor 1. Check that Nursery Unit and Parent Units are set to the same channel. 2. Place the Nursery Unit within 10 feet (3 meters) of your baby. Plug an AC adapter into the jack on the side of the Nursery Unit. Plug it into a working 120 volt AC outlet. 3. Aim the Nursery Unit toward your baby. Check that there are no walls or large objects that could block sound transmission. 4. Turn on the Nursery Unit using the ON/OFF switch. The green power light should come on. 5. Install 4—1.5V “AAA”/LRO3 batteries into the Parent Unit, or plug into a working 120 volt AC outlet using the other two AC adapters. 6. Turn on the Parent Unit using the volume control dial. The green power light should come on. 7 907-2-02 Testing the System It is VERY IMPORTANT to test the system when first set up, and at regular times thereafter. Test the units any time they may have been damaged or have not been used for a long time. 1. If two adults are present, have one take the Parent Units to different locations, trying various volume settings, while the other speaks into the Nursery Unit. 2. If only one adult is available, place a ticking clock, radio, or other sound-producing device n...
Dieses Handbuch ist für folgende Modelle:Elektrische Backöfen - 2745 (760.03 kb)