Stimmen - 4, Durchschnittliche Bewertung: 4.3
(
)
)
|
Anleitung Zusammenfassung
This is especially applicable to and important for wooden materials, coverings that adhere to edges, plastic surfaces, applied adhesives, paints and polishes. Furniture in the device's immediate vicinity must be able to with stand a temperature of at least 70°C. Matters to Pay Special Attention to Regarding the Oven's Installation Cavity! Prior to installing the device, the cutting of furniture and countertops or renovation activities need to have been completed. Sawdust and debris on the surfaces of furniture near which the product is to be installed must be cleaned. Otherwise the device's cord and electrical connection could become damaged. - For the furniture cavity dimensions and the placement of the 2 device, see the diagram. - If a drawer is to be located underneath the device, a separator panel must be placed between the device and the drawer. - Because the device is installed flush with the back wall, the electrical socket, except for the device's mounting area, must be located in an easily accessible place. - For integrated ovens, the electrical connections and installation of the stove control buttons must take into account that the stove control buttons will be on the front panel of the oven. - Ensure that the furniture cabinet of the kitchen countertop has been stabilized/immobilized. - For the oven's proper ventilation, there must be a distance of up to 35 mm between intervening furniture surfaces and the back wall. Matters to Pay Special Attention to Regarding the Positioning of the Oven - By pushing the device, insert it fully into the furniture compartment. Attention! During insertion, ensure that the electrical cable is not broken or pinched. - For air circulation, some empty space must remain between the walls and the compartment into which the device is installed. For this reason, prior to stabilizing/immobilizing the device, try to center it within the cabinet. - After positioning the device, stabilize/immobilize it with screws as shown in the diagram. - The space between the upper surface and the device must not be blocked/occupied by any object. When removing the oven from the furniture cavity, - Disconnect the device's electricity. -Unscrew the stabilization/immobilization screws. - Remove the device by slowly lifting and pulling out. * Installing your oven Assembly screws Place one each pieces which are minimum 4cm wide or as ihe deplh of cabin, the two sides of the cabin that lie oven entries. 58 i 23 Positioning of the Oven On each side of the installation cavity, position a piece of the same depth as the cabinet or at least 4 cm wide. Mounting Screws
Elektrische Backöfen - 4200 SA (745 kb)
Elektrische Backöfen - 4700 SPA (745 kb)
Elektrische Backöfen - 4700 TAA (745 kb)
Elektrische Backöfen - 4700 TBA (745 kb)