Stimmen - 4, Durchschnittliche Bewertung: 4.8 ( )

Hersteller: Bosch Dateigröße: 830.89 kb Dateiname: Unterrichtssprache:

Also, the racks will become difficult to slide in and out. 2. Clean soil from the frame around the door, outside the door gasket (see Figure 12). Do not clean the door gasket by hand as this could move or damage the gasket. The areas outside the gasket area must be cleaned by hand because these areas do not become hot enough during Self Clean to burn away the soiled spots. . Also wipe up excess grease and other food spills with a damp cloth. This will minimize the amount of smoke created during self cleaning. f 30/3 • CLEAN TIME Figure 13. . Make sure that the oven door is completely closed and the oven clock is set to the correct time. . Set the Timer/Manual Selector knob (see Figure 3) to Timer, for single oven, or to Timer Upper Oven or Timer Lower Oven, for double oven, so that oven programmer is enabled for the oven you wish to have self clean. . Set the Function Selector to Self Clean. The display will change to say SET -CLEAN TIME with an initial setting of 3 hours. If the plus (+) or minus (-) buttons are not depressed within a few seconds the display will revert to CLEAN function, as shown in Figure 14. . Set the Temperature Control to Clean. 8. If you wish to change to a cleaning time of other than 3 hours depress the COOK TIME button. A "beep" will sound and the display will show SET -CLEAN -TIME on the right hand side of the display as shown in Figure 13. The programmer setting is initially for a duration of 3 hours. The cleaning time can be set for 2 hours and 30 minutes to 4 hours depending on how soiled the oven cavity has become: > Use 2:30 -to -3:30 hours for light soil. Use 3:00 -to -3:30 hours for medium soil. Use 3:30 -to -4:00 hours for heavy soil. , To adjust the cleaning time press the plus (+) or minus (-) button, to the right of the dis play. 3:/313 .o, Figure ld. Note: If the plus (+) or minus (-) button is not depressed within 5 seconds of touching the COOK TIME button the COOK TIME button will have to be depressed again to call up SET -CLEAN -TIME. 10. After the Clean Time has been set a "beep" will sound and the indicator word CLEAN will appear in the display and the oven will begin the self cleaning process. As the oven heats past 560°F the automatic door lock will operate to lock the door of the oven that is in Self Clean. The Door Lock indicator light will become illuminated to show that the door is locked. The door will remain locked and the indicator light will remain on throughout the self cleaning process until the temperature drops below the 560°F tempera ture noted above. 11. At the end of the programmed clean time the oven will automatically shut-off. Allow the oven to cool. 12. Open the door. Then after making sure that the oven has cooled to a safe temperature, use a damp cloth or sponge to clean out the powder ash residue left in the oven. If white spots remain in the oven they can be removed with a damp sponge. These white spots are normally just salt spots that cannot be removed by self cleaning. 13. Reinstall the oven racks and broiler pan. Be sure to turn the selector knob and the temperature knob to the Off position after the electronic controlled self cleaning has been completed. Replacing an Oven Light Each oven is equipped with two halogen lights located in the back wall of the oven. The lights are switched on when the door is opened or when the oven is in a cooking cycle. The oven lights are not illuminated during SELF CLEAN. Each light as sembly consists of a removable lens, a light bulb aswell asa light socket housing that is fixed in place, see Figure 15. Light bulb replacement is considered to be a routine maintenance item. To replace a light bulb: 1. Read WARNING on this page. 2. Turn off power at the main power supply (your fuse or breaker box). Screws Fancover Bulb socket (fixed in place)_ Figure 15. Make sure the oven and lights are cool and power to the oven has been turned off before replacing the light bulb(s). Failure to do so could result in electrical shock or burns. The lenses must be in place when using the oven. The lenses serve to protectthe light bulb from breaking. The lenses are made of glass. Handle carefully to avoid breakage. Broken glass could cause an injury. . In multifunction ovens remove the fan cover by unscrewing the four screws. 4. Remove the lens by unscrewing it. 5. Remove the light bulb from its socket by pulling it. 6. Replace the bulb with a new one taking care to don't touch it with naked fingers. Their grease can damage the bulb when it becames hot. The bulb is halogen 12V-20W. , Screw the lens back on. 8. Replace the fan cover if the cavity is provided with. . Pay attention that the seal at the lamp opening is placed well in its position and is sealing the gap between opening and back of the cavity. 10. Turn the power back on at the main power supply (your fuse or breaker box). Oven Door Removal The oven door can be removed for hand cleaning if needed. Make sure oven is cool and power to the oven has been turned off b...

Herunterladen

Geben Sie zwei Ziffern: