Stimmen - 2, Durchschnittliche Bewertung: 5 ( )

Hersteller: Alto-Shaam Dateigröße: 1.66 mb Dateiname: Unterrichtssprache:

Alto-Shaam has consulted with people who understand the properties of water in order to provide water quality standards that meet the broadest possible range of acceptable water quality requirements to help protect your investment. We strongly urge water testing to ascertain the water quality on site prior to the installation of any steam producing equipment. Since water quality is an important issue, Alto-Shaam is committed to provide as much information as possible to help protect the investment made in this equipment. A CombiGuard™ Water Filtration System can be purchased as an option for installation on the Combitherm oven. This filter, when properly installed, maintained, and combined with the required levels of steam generating equipment maintenance, will help lessen the affect water has on metal surfaces. It will not, however, provide complete protection against all water damage from region to region. Due to the complexity of water chemistry, it is important to understand that water quality plays a significant role in the longevity of steam producing equipment. Water quality and required maintenance of steam generating equipment is the direct responsibility of the owner/operator. Damage incurred as a direct result of poor water quality and/or surfaces affected by water quality is also the responsibility of the owner/operator. Damage due to water quality that does not meet the minimum standards shown below is not covered under the Alto-Shaam Combitherm warranty. Alto-Shaam will continue our efforts to provide viable solutions to ease the impact of water quality as it relates to steam generating equipment. ALTO-SHAAM COMBITHERM WATER QUALITY MINIMUM STANDARDS TO PREVENT WATER PIPES OR HOSES FROM BURSTING, INCOMING WATER SUPPLY SHOULD BE TURNED OFF WHEN THE APPLIANCE IS NOT IN USE. CONTAMINANTINLETWATERREQUIREMENTS(UNTREATEDWATER) FreeChlorineLessthan0.1ppm(mg\L) HardnessLessthan3gpg(52ppm) ChlorideLessthan30ppm(mg\L) pH7.0to8.5AlkalinityLessthan50ppm(mg\L) SilicaLessthan12ppm(mg\L) TotalDissolvedSolids(tds)Lessthan60ppm GAS COMBITHERM — INSTALLATION MANUAL #MN-28676 PG. 20 COMBITHERMCOMBITHERM ®. ® ® WATER SUPPLY & INSTALLATION REQUIREMENTS WATER REQUIREMENTS TWO (2) COLD WATER INLETS -DRINKING QUALITY ONE (1) TREATED WATER INLET: 3/4" NPT* ONE (1) UNTREATED WATER INLET: 3/4" NPT* LINE PRESSURE: 30 to 90 psi 2.8 to 6.2 bar * Can manifold off of one 3/4" line REFER TO PUBLISHED SPECIFIC WATER REQUIREMENTS WATER DRAIN: 1-1/2" CONNECTION WITH AIR GAP Flush the water line at the installation site before connecting the oven to the water supply. A hose connector is supplied for flexible hose connection to the COLD water source. PIPE SEALING TAPE (TEFLON®) MUST BE USED AT ALL CONNECTION POINTS. The use of a pipe sealing compound is not recommended. ONE SUGGESTED METHOD OF INSTALLATION Incoming cold water connection Water Filter T connection NOTE: BOTH TREATED AND UNTREATED WATER CONNECTIONS MUST BE CONNECTED FOR PROPER OPERATION OF THE OVEN. BOTH CONNECTIONS CAN BE TREATED WATER, BUT SHOULD NEVER BE CONNECTED TO ONLY UNTREATED WATER. UNIONS OR FLEXIBLE LINES SHOULD BE USED TO ALLOW FOR OVEN MOVEMENT WHEN BEING SERVICED OR CLEANING IS NEEDED. REFER TO DIMENSION DRAWINGS BEGINNING ON PAGE 4 FOR PROPER INTAKE LOCATIONS. system Cold water line to Treated cold filter or treatment water to treated connection on oven Cold water line to untreated oven connection GAS COMBITHERM — INSTALLATION MANUAL #MN-28676 PG. 21 ® WATER SUPPLY & INSTALLATION REQUIREMENTS COMBITHERM SHUT-OFF VALVE SHOWN IN THE OFF POSITION NOTE: THE SHUT-OFF VALVE MUST BE IN THE OPEN POSITION WHEN THE OVEN IS BEING USED. ITEM FI-23014 Alto-Shaam now offers an improved water filtration system for Combitherm®. The CombiGuard™ triple-guard water filtration system filters dirt, sediment, and other debris as small as 1/2 micron. This system also significantly reduces chlorine content to protect against corrosive chlorine compounds. CombiGuard improves equipment efficiency, reduces service requirements and extends the life of the Combitherm. Filtration system includes one filter cartridge. Additional cartridges (FI-26356) can be purchased separately. GAS COMBITHERM — INSTALLATION MANUAL #MN-28676 PG. 22 COMBITHERMCOMBITHERM ® WATER SUPPLY & INSTALLATION REQUIREMENTS WATER DRAINAGE The oven must discharge through an indirect waste pipe by means of an air gap. The drain fitting is supplied with a 1-1/2-inch (41mm) NPT thread on one end and a 1-1/2-inch (41mm) barbed connection on the opposite end. A union is required. Install a 1-1/2-inch (41mm) diameter connection, drain line and clamp into place. The drain line must always be a positive gradient away from the Combitherm oven and not more than 12-inches (305mm) before an air gap. NOTE: In the U.S.A., this equipment is to be installed to comply with the Basic Plumbing Code of the Building Officials and Code Administrators International, Inc. [BOCA], and the Food Service Sanitation Manual of the Food & Drug...

Herunterladen

Geben Sie zwei Ziffern: