LOCATION The cooker may be located in a kitchen, kitchen/diner or a bed-sitting room, but not in a room containing a bath or shower. The cooker must not be installed in a bed-sitting room of less than 20m3. LPG models must not be installed in a room or internal space below ground level, e.g. in a basement. PROVISION FOR VENTILATION The room containing the cooker should have an air supply in accordance with BS 5440:Part 2: 1989. The room must have an opening window or equivalent; some rooms may also require a permanent vent. If the room has a volume between 5 and 10m3, it will require an air vent of 50 cm2 effective area unless it has a door which opens directly to outside. If the room has a volume of less than 5m3, it will require an air vent of 100 cm2 effective area. If there are other fuel burning appliances in the same room, BS 5440: Part 2: 1989 should be consulted to determine air vent requirements. INSTALLATION INSTRUCTIONS TECHNICAL DATA DIMENSIONS Height 900mm Width 500mm Depth 600mm (excluding door handles) GENERAL Gas connection Rp 1/2 (1/2” BSP female) Pressure test point Grill injector Gas rate adjustment None Aeration adjustment None Battery 1.5V Alkaline AA. NATURAL GAS LPG BURNER HEAT INPUT INJECTOR HEAT INPUT INJECTOR HOTPLATE Front left 3.0 kW 128 2.8 kW 82 HOTPLATE Rear left 2.0 kW 102 1.8 kW 65 HOTPLATE Rear right 1.0 kW 72 1.0 kW 50 HOTPLATE Front right 2.0 kW 102 1.8 kW 65 GRILL 3.8 kW 150 3.4 kW 95 OVEN 2.5 kW 115 2.5 kW 75 INSTALLATION INSTRUCTIONS SPACE FOR FIXING The cooker can be close fitted below hotplate level. This requires a minimum distance of 503mm between cupboard units of hotplate height. When installing next to a tall cupboard, partition or wall, for a minimum distance of 400mm above hotplate level, allow a side clearance of at least 65mm. The diagram below illustrates the minimum clearance between the cooker and adjacent walls, cupboards etc. The wall behind the cooker, 150mm below the hotplate and 450mm above, and the width of the cooker, must be a non-combustible material such as ceramic wall tiles. If the cooker is to be fitted close to a corner on the left hand side, ensure that there is a clearance of at least 50mm to allow the main oven door to open fully for when removing oven shelves. 65 mm Min840 mm Min400 mm Min 503 mm Min COOKER HOODS If a cooker hood is to be installed, refer to the cooker hood manufacturers’ instructions regarding fixing height. INSTALLATION INSTRUCTIONS UNPACKING THE COOKER Unpack the components from inside the grill and oven: Check that the following parts are present. Grill pan and grid Baking dish Oven shelves (2) Literature Aluminium burner bodies (4) Grill pan handle Pan supports (2) Enamelled discs (4) Battery 1.5V LEVELLING Four skid feet are fitted which can be adjusted up or down to level the cooker. CAUTION: Some soft floor coverings may get damaged if the cooker is not moved carefully. STABILITY BRACKET One of the holes in the rear of the cooker can be used to engage a stability bracket. The bracket must be fitted to the wall b...

Dieses Handbuch ist für folgende Modelle:
Elektrische Backöfen - 10250G (151.86 kb)
Elektrische Backöfen - 10269G Mk2 (151.86 kb)
Elektrische Backöfen - 10268G Mk2 (151.86 kb)
Elektrische Backöfen - 10266G (151.86 kb)