Stimmen - 1, Durchschnittliche Bewertung: 3
(
)
)
|
Anleitung Zusammenfassung
If you find any damaged or worn parts, DO NOT use the scooter. Contact your dealer for repairs. CHECK THE FUEL LEVEL • Check the fuel gauge. Add fuel if necessary. CHECK THE BRAKES • Apply the front and rear brakes to make sure they are working correctly. Refer to “Front and Rear Brake Adjustment” on page 12. CHECK THE TURN SIGNALS, BRAKE LIGHTS AND HORN • Turn the ignition key to the ON position to provide power to the scooter. Move the turn signal to the LEFT and RIGHT positions and make sure turn the signal lights and the turn indicator lights on the speedometer are functioning properly. • Apply the front brake and make sure the brake light is functioning properly. Repeat this test for the rear brake. • Push the horn button to make sure horn is functioning properly. CHECK THE TIRES • Make sure the tires are inflated to the proper pressures: the front tire should be inflated to 26 PSI and the rear tire should be inflated to 29 PSI. Make sure there are no cuts, punctures or excessively worn tread on the tires. Refer to “Tire Maintenance” on page 11 for details. CHECK THE REAR VIEW MIRRORS • Make sure the mirrors are clean, secured and adjusted properly so you can have a clear view of vehicles behind the scooter. Starting the Scooter WARNING • DO NOT attempt to ride the scooter until you have read and understood the purpose and operation of all the controls described earlier in this manual. • Maximum combined weight of rider and cargo must not exceed 225 lbs. (102 kg). • ALWAYS wear an approved Department of Transportation (DOT) motorcycle helmet when operating this scooter. WARNING GASOLINE ENGINES GIVE OFF CARBON MONOXIDE, AN ODORLESS, COLORLESS, POISONOUS GAS. BREATHING CARBON MONOXIDE CAN CAUSE NAUSEA, FAINTING, OR DEATH. • ALWAYS start and operate the scooter outdoors. NEVER start or run the engine in an enclosed area, even if the doors and/or windows are open. WARNING • The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Starting the Scooter, continued AUTOMATIC CHOKE NOTE: Your new scooter is equipped with an Automatic Choke. There is no manual choke and no need to apply the throttle while starting. KICK START • For the first 100 miles (160 kilometers) it is recommended that you kick start the scooter, or use the kick starter to “prime” the engine (force fuel into the carburetor) prior to using the electric starter. This preserves battery life and reduces wear to the electrical starter during the break-in period. • The center stand must be down in order to use the kick starter. NOTE: Do not attempt to sit on the seat and start the scooter with the center stand down. • Place the key in the ignition and turn it to the ON position. • Move the engine stop switch to the ON position. NOTE: The scooter will not start when the engine stop switch is in the OFF position. • Stand to the left of the scooter. Grasp the handlebar grip with your left hand and the luggage rack with your right hand. • Pull either brake lever. NOTE: The scooter will not start unless one brake is applied while starting. • Extend the kick starter foot peg. • “Kick” down on the kick starter quickly, then allow it to spring back into position. Repeat this procedure until the engine starts. NOTE: You are forcing fuel up into the carburetor with each “kick”. It may take many “kicks” to start the engine for the first time. • When the engine starts, apply enough throttle to idle the engine for 20 to 30 seconds. NOTE: DO NOT open the throttle while kick starting. Open the throttle only after the engine has started. NOTE: To prolong engine life, allow the engine to reach normal operating temperature before driving. This usually takes about 2 to 3 minutes. • Retract the kick starter foot peg to its original position before driving. • Grasp both handlebar grips and push the scooter forward to retract the center stand under the scooter. Mount the scooter. • Use the kick starter to start the scooter or prime the engine in the following situations: -If the scooter has been driven less than 100 miles (160 kilometers). -In cold or wet weather. -If the fuel tank has run completely dry (and more fuel has been added). -If the scooter has been stored for more than two weeks. -If the scooter fails to start using the electric starter button. -If the battery is discharged. ELECTRIC START • Retract the center stand and sit on the seat with both feet on ground. • Place the key in the ignition and turn it to the ON position. • Move the engine stop switch to the ON position. NOTE: The scooter will not start when the engine stop switch is in the OFF position. • Pull either brake lever. NOTE: The scooter will not start unless one brake is applied while starting. • Press the electric starter button for no more than five (5) seconds until the engine starts. Release the button as soon as the engine starts. NOTE: DO NOT press the electric starter button continuously for mor...
Dieses Handbuch ist für folgende Modelle:Rollstühle - 50SP06RD (1.49 mb)